enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Mold (cooking implement) - Wikipedia

   en.wikipedia.org/wiki/Mold_(cooking_implement)

   Bundt-style silicone and metal pans (2008) Late 19th- and early 20th-century food molds. A mould (British English) or mold (American English), is a container used in various techniques of food preparation to shape the finished dish. The term may also refer to a finished dish made in said container (e.g. a jello mold). [1]

3. Matrix (printing) - Wikipedia

   en.wikipedia.org/wiki/Matrix_(printing)

   Matrices created by Jean Jannon around 1640. The Garamond typeface installed with most Microsoft software is based on these designs. [1] [2] [3]In the manufacture of metal type used in letterpress printing, a matrix (from the Latin meaning womb or a female breeding animal) is the mould used to cast a letter, known as a sort. [4]

4. List of cakes - Wikipedia

   en.wikipedia.org/wiki/List_of_cakes

   A cake prepared firstly by lining a mold with bread, sponge cake, or biscuits; this base is then filled with fruit puree or custard. Cheesecake: Ancient Greece: A dessert with a thin base made from crushed biscuits and a thicker top layer of soft cheese, eggs and sugar. It can be baked or unbaked (in which case it is refrigerated.)

5. Investment casting - Wikipedia

   en.wikipedia.org/wiki/Investment_casting

   Produce wax patterns: Although called wax patterns, pattern materials may also include plastic and frozen mercury. [6] Wax patterns can be produced in one of two ways. In one process, the wax is poured into the mould and swished around until an even coating, usually about 3 mm (0.12 in) thick, covers the inner surface of the mould.

6. Pattern (casting) - Wikipedia

   en.wikipedia.org/wiki/Pattern_(casting)

   When the pattern is to be removed from the sand mold, there is a possibility that any leading edges may break off, or get damaged in the process. To avoid this, a taper is provided on the pattern, so as to facilitate easy removal of the pattern from the mold, and hence reduce damage to edges. The taper angle provided is called the Draft angle ...

7. Injection moulding - Wikipedia

   en.wikipedia.org/wiki/Injection_moulding

   Circular pattern around gate, normally only an issue on hot runner molds Injection speed is too fast, gate/sprue/runner size is too small, or the melt/mold temp is too low. Jetting: Jetting is a snake-like stream which occurs when polymer melt is pushed at a high velocity through restrictive areas. Poor tool design, gate position or runner.

8. Rotational molding - Wikipedia

   en.wikipedia.org/wiki/Rotational_molding

   The length of time the mold spends in the oven is critical: too long and the polymer will degrade, reducing impact strength. If the mold spends too little time in the oven, the polymer melt may be incomplete. The polymer grains will not have time to fully melt and coalesce on the mold wall, resulting in large bubbles in the polymer.

9. Molding (process) - Wikipedia

   en.wikipedia.org/wiki/Molding_(process)

   A mold or mould is a hollowed-out block that is filled with a liquid or pliable material such as plastic, glass, metal, or ceramic raw material. [2] The liquid hardens or sets inside the mold, adopting its shape. A mold is a counterpart to a cast. The very common bi-valve molding process uses two molds, one for each half of the object.