Search results
Results from the WOW.Com Content Network
The length of a machine screw or bolt is indicated by an × and the length expressed in millimetres (e.g. M8-1.25×30 or M8×30). [citation needed] Tolerance classes defined in ISO 965-1 can be appended to these designations, if required (e.g. M500– 6g in external threads). External threads are designated by lowercase letter, g or h.
The resolution 3840 × 2160, sometimes referred to as 4K UHD or 4K × 2K, has a 16:9 aspect ratio and 8,294,400 pixels. It is double the size of Full HD (1920 × 1080) in both dimensions for a total of four times as many pixels, and triple the size of HD (1280 × 720) in both dimensions for a total of nine times as many pixels. It is the lowest ...
Because the image sensors in many digital cameras are smaller than the 24 mm × 36 mm image area of full-frame 35 mm cameras, a lens of a given focal length gives a narrower field of view in such cameras. Sensor size is often expressed as optical format in inches. Other measures are also used; see table of sensor formats and sizes below.
Since most digital hardware devices use dots or pixels, the size of the media (in inches) and the number of pixels (or dots) are directly related by the 'pixels per inch'. The following formula gives the number of pixels, horizontally or vertically, given the physical size of a format and the pixels per inch of the output:
An image that is 2048 pixels in width and 1536 pixels in height has a total of 2048×1536 = 3,145,728 pixels or 3.1 megapixels. One could refer to it as 2048 by 1536 or a 3.1-megapixel image. The image would be a very low quality image (72ppi) if printed at about 28.5 inches wide, but a very good quality (300ppi) image if printed at about 7 ...
The resolution of 960H depends on whether the equipment is PAL or NTSC based: 960H represents 960 x 576 (PAL) or 960 x 480 (NTSC) pixels. [29] 960H represents an increase in pixels of some 30% over standard D1 resolution, which is 720 x 576 pixels (PAL), or 720 x 480 pixels (NTSC). The increased resolution over D1 comes as a result of a longer ...
The shank length is not always the same at the thread length, which is the case if the insert has a threadless portion (sub-shank) Tenon designates the thread length; Shoulder designates the barrel diameter in front of the thread portion; Unless otherwise mentioned, right hand threads are assumed. Left hand threads are designated "LH".
The display aspect ratio (DAR) is calculated from the physical width and height of a display, measured each in inch or cm (Display size). The pixel aspect ratio (PAR) is calculated from the width and height of one pixel. The storage aspect ratio (SAR) is calculated from the numbers of pixels in width and height stated in the display resolution.