Search results
Results from the WOW.Com Content Network
Device for Connection of Luminaires (DCL) is a European standard for ceiling light fixtures introduced in 2005 and refined in 2009. It uses 6 ampere. DCL must carry the CE marking as per the Low Voltage Directive. DCL is only allowed to be installed with ground. Example of DCL socket.
A lightbulb socket, lightbulb holder, light socket, lamp socket or lamp holder is a device which mechanically supports and provides electrical connections for a compatible electric lamp base. [1] Sockets allow lamps to be safely and conveniently replaced (re-lamping).
REDEL 6-pin connector by LEMO, known as "LEMO plugs". [10] [1] Most Cirrus aircraft use this connector. [9] Fischer 8-pin connector, used in Agusta helicopters [5] Neutrik neutriCON 8-pin connector [11] [12] [13] The XLR, LEMO and Fischer plugs are able to supply power for active noise cancellation. [5]
The suffix after the G indicates the pin spread; the G dates to the use of Glass for the original bulbs. GU usually also indicates that the lamp provides a mechanism for physical support by the luminaire: in some cases, each pin has a short section of larger diameter at the end (sometimes described as a "peg" rather than a "pin" [2]); the socket allows the bulb to lock into place by twisting ...
The telephone jack of manual telephone switchboards, which is the socket fitting the original 1 ⁄ 4 inch (6.35 mm) telephone plug; The 1 ⁄ 4 inch (6.35 mm) phone jack common to many electronic applications in various configurations, sometimes referred to as a headphone jack
Common uses of phone plugs and their matching sockets include: Headphone and earphone jacks on a wide range of equipment. 6.35 mm (1 ⁄ 4 in) plugs are common on home and professional audio equipment, while 3.5 mm plugs are nearly universal for portable audio equipment and headphones. 2.5 mm plugs are not as common, but are used on ...
JST manufactures numerous series (families) and pitches (pin-to-pin distance) of connectors. [ 2 ] [ 3 ] JST connectors are used in many types of products, and commonly used by electronics hobbyists and consumer products for rechargeable battery packs, battery balancers , battery eliminator circuits , 3D printers , and radio controlled servos .
The GU24 fitting is intended to maintain the energy efficiency of the light by preventing an occupant from using an incandescent bulb instead of a CFL. Adapters to use incandescent bulbs in a GU24 fitting are illegal in the State of California as they would be a fire hazard in fixtures designed for the lower heat output of a CFL bulb. [2]