Search results
Results from the WOW.Com Content Network
By 2008, a report by the United States Department of Energy ranked the firm as fifth in the US in the central air conditioner and heat pump market with a 12% market share (behind UTC/Carrier with 27%, both Goodman/Amana and American Standard/Trane with 14% and Lennox with 12%), while in the residential gas furnace market as of 2008, the company ...
Ruud was issued his patent for the coiled tube Automatic Water Heater on September 6, 1898. [17] A 1915 diagram showing the innards of a Ruud instantaneous water heater. Ruud's business expanded as he popularized and improved on his instant water heater design. In 1908, Ruud Manufacturing acquired two local heating and plumbing firms.
AMPS is made by the Ritter reaction of acrylonitrile and isobutylene in the presence of sulfuric acid and water. [2] The recent patent literature [3] describes batch and continuous processes that produce AMPS in high purity (to 99.7%) and improved yield (up to 89%, based on isobutene) with the addition of liquid isobutene to an acrylonitrile / sulfuric acid / phosphoric acid mixture at 40°C.
Wire sized 1 AWG is referred to as "one gauge" or "No. 1" wire; similarly, thinner sizes are pronounced "x gauge" or "No. x" wire, where x is the positive-integer AWG number. Consecutive AWG wire sizes thicker than No. 1 wire are designated by the number of zeros: No. 0, often written 1/0 and referred to as "one-aught" or "single-aught" wire
The first of the cooling load factors used in this method is the CLTD, or the Cooling Load Temperature Difference. This factor is used to represent the temperature difference between indoor and outdoor air with the inclusion of the heating effects of solar radiation. [1] [5] The second factor is the CLF, or the cooling load factor.
Some air conditioning equipment manufacturers install crankcase heaters either in the compressor (insertion type), or mount them externally around the base of the compressor (bellyband type). The two wires of the heater are wired directly to the input side of the contact from the main power supply, and power is always supplied to the heater.
Air-conditioner sizes are often given as "tons" of cooling, where 1 ton of cooling equals 12,000 BTU/h (3.5 kW). 1 ton of cooling equals the amount of power that needs to be applied continuously over a 24-hour period to melt 1 ton of ice. The annual cost of electric energy consumed by an air conditioner may be calculated as follows:
A power conditioner (also known as a line conditioner or power line conditioner) is a device intended to improve the quality of the power that is delivered to electrical load equipment. The term most often refers to a device that acts in one or more ways to deliver a voltage of the proper level and characteristics to enable load equipment to ...