enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Pentalobular screw thread - Wikipedia

   en.wikipedia.org/wiki/Pentalobular_screw_thread

   A pentalobular screw thread is a form of self-forming thread used for screws. Self-forming screws are used in ductile materials, such as aluminium and plastics. Self-tapping screws are widely used for driving into sheet metal or plastics and forming their own thread. They may be either self-drilling, forming their own hole through unbroken ...

3. Self-tapping screw - Wikipedia

   en.wikipedia.org/wiki/Self-tapping_screw

   A self-tapping screw is a screw that can tap its own hole as it is driven into the material. More narrowly, self-tapping is used only to describe a specific type of thread-cutting screw intended to produce a thread in relatively soft material or sheet materials, excluding wood screws .

4. List of screw and bolt types - Wikipedia

   en.wikipedia.org/wiki/List_of_screw_and_bolt_types

   self-tapping machine screw: A self-tapping machine screw is similar to a machine screw, except the lower part of the shank is designed to cut threads as the screw is driven into an untapped hole. The advantage of this screw type over a self-drilling screw is that, if the screw is reinstalled, new threads are not cut as the screw is driven. set bolt

5. Pocket-hole joinery - Wikipedia

   en.wikipedia.org/wiki/Pocket-hole_joinery

   Pocket screws have a wide washer head to spread the load for a firm bond, and prevent screwing too far into the joint and cracking the wood. The self tapping screws will grip any type of wood, but coarse threads are needed for softer wood and fine threads are needed for harder. [5]

6. List of drill and tap sizes - Wikipedia

   en.wikipedia.org/wiki/List_of_drill_and_tap_sizes

   Example (inch, fine): For 7 ⁄ 16-20 (same diameter as the previous example, but this time with 20 threads per inch, which is considered fine), 0.437 in × 0.90 = 0.393 in (i.e., if the threads are to be fine, then a slightly larger diameter drill bit should be used before tapping the hole for the screw). The drill sizes that are near this are ...

7. Tap and die - Wikipedia

   en.wikipedia.org/wiki/Tap_and_die

   The operator guides the tapping head to each (already-drilled) hole and quickly taps it. Drilling and tapping centers, whose name sounds similar to that of tapping stations, are actually light-duty, affordable machining centers of 2, 2.5, or 3 axes that are designed for a life of mainly drilling and tapping with limited milling use.