Search results
Results from the WOW.Com Content Network
The Killer NIC comes in 2 models; the K1 and the M1.Both models contain a Freescale PowerQUICC processor, 64 MB RAM, a single Gigabit Ethernet port, as well as a single USB 2.0 port, intended for use with specialized programs running on the card's embedded Linux operating system.
Limiting the speed of data sent by a data originator (a client computer or a server computer) is much more efficient than limiting the speed in an intermediate network device between client and server because while in the first case usually no network packets are lost, in the second case network packets can be lost / discarded whenever ingoing data speed overcomes the bandwidth limit or the ...
In a network simulation model with infinite packet queues, the asymptotic throughput occurs when the latency (the packet queuing time) goes to infinity, while if the packet queues are limited, or the network is a multi-drop network with many sources, and collisions may occur, the packet-dropping rate approaches 100%.
Once synced with your internet provider (it’s compatible with most major services), the Eero 6 Mesh Wi-Fi Router can cover up to 1,500 square feet with speeds up to 900 Mbps. Unlike a Wi-Fi ...
The algorithms speed up the data transfer until packets start to drop, then slow down the transmission rate. Ideally, they keep adjusting the transmission rate until it reaches an equilibrium speed of the link. So that the algorithms can select a suitable transfer speed, the feedback about packet drops must occur in a timely manner.
Autonegotiation is a signaling mechanism and procedure used by Ethernet over twisted pair by which two connected devices choose common transmission parameters, such as speed, duplex mode, and flow control. In this process, the connected devices first share their capabilities regarding these parameters and then choose the highest-performance ...
In a single-channel configuration, only one module at a time can transfer information to the CPU. In multi-channel configurations, multiple modules can transfer information to the CPU at the same time, in parallel. FPM, EDO, SDR, and RDRAM memory was not commonly installed in a dual-channel configuration.
TCP offload engine (TOE) is a technology used in some network interface cards (NIC) to offload processing of the entire TCP/IP stack to the network controller. It is primarily used with high-speed network interfaces, such as gigabit Ethernet and 10 Gigabit Ethernet, where processing overhead of the network stack becomes significant.