Search results
Results from the WOW.Com Content Network
A flash boiler is a type of water-tube boiler. The tubes are close together and water is pumped through them. A flash boiler differs from the type of monotube steam generator in which the tube is permanently filled with water. In a flash boiler, the tube is kept so hot that the water feed is quickly flashed into steam and superheated.
In natural gas furnaces, water heaters, and room heating systems, a safety cut-off switch is normally included so that the gas supply to the pilot and heating system is shut off by an electrically operated valve if the pilot light goes out. This cut-off switch usually detects the pilot light in one of several ways: A flame rectification device. [2]
A high pressure watertube boiler [1] (also spelled water-tube and water tube) is a type of boiler in which water circulates in tubes heated externally by fire. Fuel is burned inside the furnace, creating hot gas which boils water in the steam-generating tubes.
The top has a small outlet, usually hidden beneath a plastic dust cap. Internally there is a large hollow body, normally filled with water, and containing a float valve. The valve must always be installed vertically, usually at the top of a short vertical pipe. If the valve body is filled with water, the float moves upwards and closes the valve.
An industrial furnace, also known as a direct heater or a direct fired heater, is a device used to provide heat for an industrial process, typically higher than 400 degrees Celsius. [1] They are used to provide heat for a process or can serve as reactor which provides heats of reaction.
The water to the slide flows through a pipe which doubles as the tower holding the steps to the slide. When the facility with the slide closes for the night, the check valve stops the flow of water through the pipe; when the facility reopens for the next day, the valve is opened and the flow restarts, making the slide ready for use again. [13]
Light Ball (UP22) no image: 2017 The Dyson Light Ball (UP22) is the replacement for the DC40 (ERP) upright, and is similar to the DC40 ERP in many respects except that it has a totally redesigned powerhead, incorporating a direct-drive, large-diameter brushroll with an internal "epicyclic" geared motor, similar to the DC50 and Small Ball.
An induction furnace is an electrical furnace in which the heat is applied by induction heating of metal. [ 1 ] [ 2 ] [ 3 ] Induction furnace capacities range from less than one kilogram to one hundred tons, and are used to melt iron and steel , copper , aluminum , and precious metals .