Search results
Results from the WOW.Com Content Network
A hydraulic cylinder is the actuator or "motor" side of this system. The "generator" side of the hydraulic system is the hydraulic pump which delivers a fixed or regulated flow of oil to the hydraulic cylinder, to move the piston. There are three types of pump widely used: hydraulic hand pump, hydraulic air pump, and hydraulic electric pump.
An actuator is a component of a machine that produces force, torque, or displacement, when an electrical, pneumatic or hydraulic input is supplied to it in a system (called an actuating system). The effect is usually produced in a controlled way. [1] An actuator translates such an input signal into the required form of mechanical energy.
Another critical speed at mode 4 is observed at 7810 rpm (130 Hz) in dangerous vicinity of nominal shaft speed, but it has 30% damping - enough to safely ignore it. Analytically computed values of eigenfrequencies as a function of the shaft's rotation speed. This case is also called "whirl speed map". [4] Such a chart can be used in turbine design.
If a hydraulic rotary pump with the displacement 10 cc/rev is connected to a hydraulic rotary motor with 100 cc/rev, the shaft torque required to drive the pump is one-tenth of the torque then available at the motor shaft, but the shaft speed (rev/min) for the motor is also only one-tenth of the pump shaft speed.
The speed and force of an actuator depend on its gearbox. The amount of force depends on the actuator’s speed. Lower speeds supply greater force because motor speed and force are constant. One of the basic differences between actuators is their stroke, which is defined by the length of the screw and shaft.
Cutting speed may be defined as the rate at the workpiece surface, irrespective of the machining operation used. A cutting speed for mild steel of 100 ft/min is the same whether it is the speed of the cutter passing over the workpiece, such as in a turning operation, or the speed of the cutter moving past a workpiece, such as in a milling operation.
Most systems employ eddy current, oil hydraulic, or DC motor produced loads because of their linear and quick load change abilities. The power is calculated as the product of angular velocity and torque. A motoring dynamometer acts as a motor that drives the equipment under test. It must be able to drive the equipment at any speed and develop ...
Another way of changing speed of a direct current motor is to change the voltage applied to the armature. An adjustable-speed motor drive might consist of an electric motor and controller that is used to adjust the motor's operating speed. The combination of a constant-speed motor and a continuously adjustable mechanical speed-changing device ...