Search results
Results from the WOW.Com Content Network
The Dead Sea is receding at a swift rate; its surface area today is 605 km 2 (234 sq mi), having been 1,050 km 2 (410 sq mi) in 1930. Multiple canal and pipeline proposals, such as the scrapped Red Sea–Dead Sea Water Conveyance project, [11] have been made to reduce its recession.
Seawater, or sea water, is water from a sea or ocean. On average, seawater in the world's oceans has a salinity of about 3.5% (35 g/L, 35 ppt, 600 mM). This means that every kilogram (roughly one liter by volume) of seawater has approximately 35 grams (1.2 oz) of dissolved salts (predominantly sodium ( Na +
Seawater typically has a mass salinity of around 35 g/kg, although lower values are typical near coasts where rivers enter the ocean. Rivers and lakes can have a wide range of salinities, from less than 0.01 g/kg [3] to a few g/kg, although there are many places where higher salinities are found. The Dead Sea has a salinity of more than 200 g ...
where TDS is expressed in mg/L and EC is the electrical conductivity in microsiemens per centimeter at 25 °C. The conversion factor k e varies between 0.55 and 0.8. [5] Some TDS meters use an electrical conductivity measurement to the ppm using the above formula. Regarding units, 1 ppm indicates 1 mg of dissolved solids per 1,000 g of water. [6]
The specific weight, also known as the unit weight (symbol γ, the Greek letter gamma), is a volume-specific quantity defined as the weight W divided by the volume V of a material: = / Equivalently, it may also be formulated as the product of density, ρ, and gravity acceleration, g: = Its unit of measurement in the International System of Units (SI) is newton per cubic metre (N/m 3), with ...
With these two coefficients, the density ratio can be calculated. This determines the contribution of the temperature and salinity to the density of a water parcel. β is called a contraction coefficient, because when salinity increases, water becomes denser, and if the temperature increases, water becomes less dense.
Liquid water has a density of approximately 1 g/cm 3 (1 g/mL). Thus 100 mL of water is equal to approximately 100 g. Thus 100 mL of water is equal to approximately 100 g. Therefore, a solution with 1 g of solute dissolved in final volume of 100 mL aqueous solution may also be considered 1% m/m (1 g solute in 99 g water).
The density ratio of a column of seawater is a measure of the relative contributions of temperature and salinity in determining the density gradient. [1] At a density ratio of 1, temperature and salinity are said to be compensated : their density signatures cancel, leaving a density gradient of zero.