Ads
related to: sbc 400 main bearing size
Search results
Results from the WOW.Com Content Network
The 400 is the only engine that uses a 2.65 in (67.3 mm) main bearing journal and a 2.1 in (53.3 mm) rod bearing journal. The connecting rod was also 400 specific being 5.565 in (141.4 mm) as opposed to the 5.7 in (144.8 mm) rod used in all other small-block Chevrolet engines.
For 1957 the V8's stroke was increased to 3.5625 in (90.49 mm), for a displacement of 347 cu in (5.7 L) and the main bearing size was increased to 2.625. For the first time, Pontiac offered Tri-Power, three two-barrel carburetors with a sequential linkage (replacing the previous dual-quad set-up). Power ratings increased with the increase in ...
The big-block engines initially used a forged crankshaft with a stroke of 3.975" for the 1965-1967 425 and 400 CID versions; starting in 1968, both the 400 cu in (6.6 L) and the 455 cu in (7.5 L) big blocks used a stroke of 4.25 in (108 mm), with crankshaft material changed to cast iron except in a few rare cases.
The Chevrolet small-block engine refers to one of the several gasoline-powered vehicle engines manufactured by General Motors. These include: The first or second generation of non-LS Chevrolet small-block engines; The third, fourth, or fifth generation of LS-based GM engines; The Chevrolet Gemini small-block engine
The 400 cu in (6.6 L) B engine was introduced in 1972 to replace the venerable 383, and were power-rated via the net (installed) method. Chrysler increased the bore size of the 383 to create the 400. Its bore of 4.342-inch (110.3 mm) was the largest used in any production Chrysler V8 at the date of its introduction.
The small-block's 4.4 in (110 mm) bore spacing is retained, requiring pressed-in cylinder liners. The crankshaft and main bearing caps are forged steel for durability, the connecting rods are forged titanium, and the pistons are hypereutectic. The two-valve arrangement is retained, though the titanium intake valves by Del West have grown to 2.2 ...
Ads
related to: sbc 400 main bearing size