Search results
Results from the WOW.Com Content Network
Equipment; flow table, Abrams cone, water bucket and broom. The cone filled with concrete, prior to lifting. The diameter of the resulting flow is measured. The flow table test or slump-flow test is a method to determine consistency of fresh concrete. Flow table test is also used to identify transportable moisture limit of solid bulk cargoes. [1]
Early diagnosis and analysis of seemingly healthy concrete cover and reinforcement status allows pre-emptive corrosion control measures to reduce unwanted risks to structural safety. [3] Bundesanstalt für Materialforschung und -prüfung (Federal Institute for Materials Research and Testing, Germany) has developed a sensor equipped robotic ...
N-Bromosuccinimide or NBS is a chemical reagent used in radical substitution, electrophilic addition, and electrophilic substitution reactions in organic chemistry. NBS can be a convenient source of Br • , the bromine radical.
The test involves filling the vessel or pipe system with a liquid, usually water, which may be dyed to aid in visual leak detection, and pressurization of the vessel to the specified test pressure. Pressure tightness can be tested by shutting off the supply valve and observing whether there is a pressure loss.
The low-end test equipment is dominated by few large suppliers, notably Germany's Loviband and Merck, DelAgua & ITS Europe Water Testing of the UK who work globally, and US-based LaMotte. Major manufacturers of in-line equipment include Siemens and Danaher's Hach. Thermo Scientific and Waters are key producers of high-end test equipment. [38]
Epoxy moisture control systems can be applied over concrete with relative humidity levels up to 100%, and there are systems available on the market today that can be applied over concrete that is physically damp. In some cases, with the use of an epoxy moisture control system, floor coverings can be installed just 7 days after the slab is poured.
A hydrostatic test involves pressurising the cylinder to its test pressure (usually 5/3 or 3/2 of the working pressure) and measuring its volume before and after the test. A permanent increase in volume above the tolerated level means the cylinder fails the test and must be permanently removed from service. [3]: sect. 5.7.3
Environmental testing is the measurement of the performance of equipment under specified environmental conditions. [1] This can include the following: [2] [3] High and low extreme temperatures; Temperature cycling; Sand and dust exposure; Salt spray; High and low humidity; Wet environments; Deep water submersion; Corrosive material exposure ...