Search results
Results from the WOW.Com Content Network
Newer automatic transmission designs often use many pressure control solenoids, and sometimes allow the shift solenoids themselves to provide precise pressure control during shifts by ramping the solenoid on and off. The shift pressure affects the shift quality (too high a pressure will result in rough shifting; too low a pressure will cause ...
There was a "signal" button which was the horn. A housing containing four large solenoids was mounted at the transmission which acted on the steel transmission shift control rods. The driver was free to select any gear at will, enabling the bypassing of gears, such as jumping from first to third gear without going through second gear. [2]
A variable force solenoid (VFS) is an electro-hydraulic device that controls pressure proportionally or inversely proportionally to a signal (voltage or current) obtained from the on-board controller of a powertrain. A low flow VFS is used as a signal level devices for transmission line pressure control or application of clutches.
Steering wheel with column-mounted gear lever in a W 120-series Mercedes-Benz 180 Column shifter for an automatic transmission in a Ford Crown Victoria. Gear sticks are most commonly found between the front seats of the vehicle, either on the center console (sometimes even quite far up on the dashboard), the transmission tunnel (erroneously called a console shifter when the floor shifter ...
This allows for more precise control of shift points, shift quality, lower shift times and manual control. The first five-speed automatic was the ZF 5HP18 transmission, debuting in 1991 on various BMW models. The first six-speed automatic was the ZF 6HP26 transmission, which debuted in the 2002 BMW 7 Series (E65).
A semi-automatic transmission is a multiple-speed transmission where part of its operation is automated (typically the actuation of the clutch), but the driver's input is still required to launch the vehicle from a standstill and to manually change gears.
Although the IAC is supposed to last the vehicle's lifetime, various reasons may cause it to fail/malfunction prematurely. The most common failure mode is partial/complete jamming of the actuator (due to dirt/dust or even oil) where it cannot be smoothly controlled. The result is an engine that fails to maintain idle RPM and frequently stalls.
Trapped key interlock transfer block. Another example is an electric kiln. To prevent access to the inside of an electric kiln, a trapped key system may be used to interlock a disconnecting switch and the kiln door. While the switch is turned on, the key is held by the interlock attached to the disconnecting switch.