enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Fast Ethernet - Wikipedia

   en.wikipedia.org/wiki/Fast_Ethernet

   Fast Ethernet is an extension of the 10-megabit Ethernet standard. It runs on twisted pair or optical fiber cable in a star wired bus topology , similar to the IEEE standard 802.3i called 10BASE-T , itself an evolution of 10BASE5 (802.3) and 10BASE2 (802.3a).

3. Category 5 cable - Wikipedia

   en.wikipedia.org/wiki/Category_5_cable

   The cable standard prescribes performance parameters for frequencies up to 100 MHz and is suitable for 10BASE-T, 100BASE-TX (Fast Ethernet), 1000BASE-T (Gigabit Ethernet), and 2.5GBASE-T. 10BASE-T and 100BASE-TX Ethernet connections require two wire pairs. 1000BASE-T and faster Ethernet connections require four wire pairs.

4. 2.5GBASE-T and 5GBASE-T - Wikipedia

   en.wikipedia.org/wiki/2.5GBASE-T_and_5GBASE-T

   The development of the 2.5GBASE-T and 5GBASE-T standards enabled wireless access points to reach their maximum speeds without being limited by the Ethernet uplink speeds over a single existing Cat5e cable, while also being compatible with newer Cat6 and Cat6a cabling.

5. Terabit Ethernet - Wikipedia

   en.wikipedia.org/wiki/Terabit_Ethernet

   Terabit Ethernet (TbE) is Ethernet with speeds above 100 Gigabit Ethernet. The 400 Gigabit Ethernet ( 400G , 400GbE ) and 200 Gigabit Ethernet ( 200G , 200GbE ) [ 1 ] standard developed by the IEEE P802.3bs Task Force using broadly similar technology to 100 Gigabit Ethernet [ 2 ] [ 3 ] was approved on December 6, 2017.

6. List of interface bit rates - Wikipedia

   en.wikipedia.org/wiki/List_of_interface_bit_rates

   Device interfaces where one bus transfers data via another will be limited to the throughput of the slowest interface, at best. For instance, SATA revision 3.0 (6 Gbit/s) controllers on one PCI Express 2.0 (5 Gbit/s) channel will be limited to the 5 Gbit/s rate and have to employ more channels to get around this problem.

7. Ethernet over twisted pair - Wikipedia

   en.wikipedia.org/wiki/Ethernet_over_twisted_pair

   Most Ethernet cables are wired straight-through (pin 1 to pin 1, pin 2 to pin 2, and so on). In some instances, the crossover form (receive to transmit and transmit to receive) may still be required. Cables for Ethernet may be wired to either the T568A or T568B termination standards at both ends of the cable. Since these standards differ only ...