Search results
Results from the WOW.Com Content Network
Reinforcing rebar is placed axially in the column to provide additional axial stiffness. Accounting for the additional stiffness of the steel, the nominal loading capacity P n for the column in terms of the maximum compressive stress of the concrete f c ' , the yield stress of the steel f y , the gross cross section area of the column A g , and ...
The design of tension members requires careful analysis of potential failure modes, specifically yielding (excessive deformation) and fracture, which are referred to as limit states. The governing limit state is the one that results in the lowest design strength, as it dictates the member's capacity and prevents structural failure.
A column under a centric axial load exhibiting the characteristic deformation of buckling. When subjected to compressive forces it is possible for structural elements to deform significantly due to the destabilising effect of that load. The effect can be initiated or exacerbated by possible inaccuracies in manufacture or construction.
In the quasi-static case, the amount of bending deflection and the stresses that develop are assumed not to change over time. In a horizontal beam supported at the ends and loaded downwards in the middle, the material at the over-side of the beam is compressed while the material at the underside is stretched.
Dead loads have small load factors, such as 1.2, because weight is mostly known and accounted for, such as structural members, architectural elements and finishes, large pieces of mechanical, electrical and plumbing (MEP) equipment, and for buildings, it's common to include a Super Imposed Dead Load (SIDL) of around 5 pounds per square foot ...
The increased stresses due to the combined axial-plus-flexural stresses result in a reduced load-carrying ability. Column elements are considered to be massive if their smallest side dimension is equal to or more than 400 mm. Massive columns have the ability to increase in carrying strength over long time periods (even during periods of heavy ...
In the context to structural analysis, a structure refers to a body or system of connected parts used to support a load. Important examples related to Civil Engineering include buildings, bridges, and towers; and in other branches of engineering, ship and aircraft frames, tanks, pressure vessels, mechanical systems, and electrical supporting structures are important.
The total elastic energy due to strain can be divided into two parts: one part causes change in volume, and the other part causes a change in shape. Distortion energy is the amount of energy that is needed to change the shape. Fracture mechanics was established by Alan Arnold Griffith and George Rankine Irwin. This important theory is also ...