Search results
Results from the WOW.Com Content Network
Buckling may occur even though the stresses that develop in the structure are well below those needed to cause failure in the material of which the structure is composed. . Further loading may cause significant and somewhat unpredictable deformations, possibly leading to complete loss of the member's load-carrying capac
The deformation may not be uniform and may not be aligned with the compression forces. What happens in the directions where there is no compression depends on the material. [ 4 ] Most materials will expand in those directions, but some special materials will remain unchanged or even contract.
In other words, any deformation due to shear across the section is not accounted for (no shear deformation). Also, this linear distribution is only applicable if the maximum stress is less than the yield stress of the material. For stresses that exceed yield, refer to article plastic bending.
For thick plates, we have to consider the effect of through-the-thickness shears on the orientation of the normal to the mid-surface after deformation. Raymond D. Mindlin's theory provides one approach for find the deformation and stresses in such plates. Solutions to Mindlin's theory can be derived from the equivalent Kirchhoff-Love solutions ...
[1] [2] A load causes stress, deformation, displacement or acceleration in a structure. Structural analysis, a discipline in engineering, analyzes the effects of loads on structures and structural elements. Excess load may cause structural failure, so this should be considered and controlled during the design of a structure.
A column under a centric axial load exhibiting the characteristic deformation of buckling. When subjected to compressive forces it is possible for structural elements to deform significantly due to the destabilising effect of that load. The effect can be initiated or exacerbated by possible inaccuracies in manufacture or construction.
Sample deformation mechanism map for a hypothetical material. Here there are three main regions: plasticity, power law creep, and diffusional flow. A deformation mechanism map is a way of representing the dominant deformation mechanism in a material loaded under a given set of conditions. The technique is applicable to all crystalline materials ...
The design of tension members requires careful analysis of potential failure modes, specifically yielding (excessive deformation) and fracture, which are referred to as limit states. The governing limit state is the one that results in the lowest design strength, as it dictates the member's capacity and prevents structural failure.