Search results
Results from the WOW.Com Content Network
The reset vector for MIPS32 processors is at virtual address 0xBFC00000, [11] which is located in the last 4 Mbytes of the KSEG1 non-cacheable region of memory. [12] The core enters kernel mode both at reset and when an exception is recognized, hence able to map the virtual address to physical address. [13]
In addition to these, a small core of other special function registers – including the interrupt enable IE at A8 and interrupt priority IP at B8; the I/O ports P0 (80), P1 (90), P2 (A0), P3 (B0); the serial I/O control SCON (98) and buffer SBUF (99); the CPU/power control register PCON (87); and the registers for timers 0 and 1 control (TCON ...
Each entry of the interrupt vector table, called an interrupt vector, is the address of an interrupt handler (also known as ISR). While the concept is common across processor architectures, IVTs may be implemented in architecture-specific fashions. For example, a dispatch table is one method of implementing an interrupt vector table.
The Small Device C Compiler (SDCC) is a free-software, partially retargetable [1] C compiler for 8-bit microcontrollers. It is distributed under the GNU General Public License. The package also contains an assembler, linker, simulator and debugger. SDCC is a popular open-source C compiler for microcontrollers compatible with Intel 8051/MCS-51 ...
Direct address: ADD.A address 1 — add the value stored at address 1; Memory indirect: ADD.M address 1 — read the value in address 1, use that value as another address and add that value; Many ISAs also have registers that can be used for addressing as well as math tasks. This can be used in a one-address format if a single address register ...
Address is only valid for one cycle. C/BE will provide the command following by first data phase byte enables; On the rising edge of clock 0, the initiator observes FRAME# and IRDY# both high, and GNT# low, so it drives the address, command, and asserts FRAME# in time for the rising edge of clock 1. Targets latch the address and begin decoding it.
An example of this approach is the MOS 6502, which had only a single register, in which case it is referred to as the accumulator, and a special "zero page" addressing mode that treated the first 256 bytes of memory as if they were registers. Placing code and data in the zero page meant the instruction was only two bytes long instead of three ...
In computer architecture, a control bus is part of the system bus and is used by CPUs for communicating with other devices within the computer. While the address bus carries the information about the device with which the CPU is communicating and the data bus carries the actual data being processed, the control bus carries commands from the CPU and returns status signals from the devices.