Ad
related to: 4l80e pressure control solenoid testebay.com has been visited by 1M+ users in the past month
- Easy Returns
Whether You Shop or Sell.
We Make Returns Easy.
- Gift Cards
eBay Gift Cards to the Rescue.
Give The Gift You Know They’ll Love
- Easy Returns
Search results
Results from the WOW.Com Content Network
The 4L80-E uses two shift solenoids, initially called Shift Solenoid A and Shift Solenoid B; they were later changed to comply with OBD-II regulations to 1-2 shift solenoid and 2-3 shift solenoid. By activating and deactivating the solenoids in a predetermined pattern by the PCM, four distinct gear ratios can be achieved.
The early designs simple on or off lockup function while the later design can regulate the apply pressure as to not feel the lock up occur. GM added a fifth solenoid to the valve body, called the PWM solenoid. In 1996, GM introduced a redesigned 4L60E transmission case that incorporated a bolt-on bellhousing and a six-bolt tail housing.
Newer automatic transmission designs often use many pressure control solenoids, and sometimes allow the shift solenoids themselves to provide precise pressure control during shifts by ramping the solenoid on and off. The shift pressure affects the shift quality (too high a pressure will result in rough shifting; too low a pressure will cause ...
A variable force solenoid (VFS) is an electro-hydraulic device that controls pressure proportionally or inversely proportionally to a signal (voltage or current) obtained from the on-board controller of a powertrain. A low flow VFS is used as a signal level devices for transmission line pressure control or application of clutches.
A transmission solenoid or cylinoid is an electro-hydraulic valve that controls fluid flow into and throughout an automatic transmission. Solenoids can be normally open or normally closed. They operate via a voltage or current supplied by the transmission computer or controller.
A 3-port solenoid-type boost controller A 4-port solenoid-type boost controller (used for a dual-port wastegate). The purpose of a boost controller is to reduce the boost pressure seen by the wastegate's reference port, in order to trick the wastegate into allowing higher boost pressures than it was designed for.
By activating and deactivating the solenoids in a predetermined pattern by the PCM, 4 distinct gear ratios can be achieved. The last 4L60Es were only used in the GM Vans in 2013, before being replaced by the 6L80E. The shift solenoid pattern, also sometimes referred to as solenoid firing order, is as follows; Shift Solenoid Pattern
Electronic control of shift pattern (when it shifts), shift timing (how long it takes to shift), shift quality (shift feel), line pressure, and TCC apply and release rates were all affected by the cold temperature performance of the ATF flowing through solenoids. In 1990, DEXRON-II (E) (GM Spec GM6137M) was released.
Ad
related to: 4l80e pressure control solenoid testebay.com has been visited by 1M+ users in the past month