Search results
Results from the WOW.Com Content Network
A sewer pipe is normally at neutral air pressure compared to the surrounding atmosphere.When a column of waste water flows through a pipe, it compresses air ahead of it in the system, creating a positive pressure that must be released so it does not push back on the waste stream and downstream traps, slow drainage, and induce potential clogs.
The United States Environmental Protection Agency (EPA) issues Effluent Guideline regulations for categories of industrial sources of water pollution under Title III of the Clean Water Act (CWA). [1] The standards are technology-based, i.e. they are based on the performance of treatment and control technologies (e.g., Best Available Technology ).
A Discharge Monitoring Report (DMR) is a United States regulatory term for a periodic water pollution report prepared by industries, municipalities and other facilities discharging to surface waters. [ 1 ] : 8–14 The facilities collect wastewater samples, conduct chemical and/or biological tests of the samples, and submit reports to a state ...
Water pollution is the contamination of natural water bodies by chemical, physical, radioactive or pathogenic microbial substances. [2] Point sources of water pollution are described by the CWA as "any discernible, confined, and discrete conveyance from which pollutants are or may be discharged."
According to the International Residential Code 2003, an air gap length must meet the requirements of being two times the effective inner diameter of the pipe (2×D) in order to be sufficient. [2] A standard widely use in the United States is: A112.1.2 Air Gaps in Plumbing Systems (For Plumbing Fixtures and Water-Connected Receptors)
The Urban Waste Water Treatment Directive (full title "Council Directive 91/271/EEC of 21 May 1991 concerning urban waste-water treatment") is a European Union directive regarding urban wastewater collection, wastewater treatment and its discharge, as well as the treatment and discharge of "waste water from certain industrial sectors".
A Fixture Unit is not a flow rate unit but a design factor. A fixture unit is equal to 1 cubic foot (0.028 m 3) of water drained in a 1 + 1 ⁄ 4 inches (32 mm) diameter pipe over one minute. [2] One cubic foot of water is roughly 7.48 US gallons (28.3 L; 6.23 imp gal). A Fixture Unit is used in plumbing design for both water supply and waste ...
Effluent pumping systems have pipes that are buried at a constant depth, such as a metre and a half, and rely on pumping stations that create pressure to move the waste to a treatment facility. An effluent sewer that uses gravity may be called a septic tank effluent gravity (STEG) system, while a pumping system may be called a septic tank ...