Search results
Results from the WOW.Com Content Network
A beam waveguide antenna is a type of complicated Cassegrain antenna with a long radio wave path to allow the feed electronics to be located at ground level. It is used in very large steerable radio telescopes and satellite ground antennas, where the feed electronics are too complicated and bulky, or requires too much maintenance and alterations, to locate on the dish; for example those using ...
In electronics, an antenna amplifier (also: aerial amplifier or booster) is a device that amplifies an antenna signal, usually into an output with the same impedance as the input impedance. Typically 75 ohm for coaxial cable and 300 ohm for twin-lead cable. An antenna amplifier boosts a radio signal considerably for devices that receive radio ...
The first full scale beam waveguide antenna was the 64 meter antenna at the Usuda Deep Space Center, Japan, built in 1984 by the Japan Aerospace Exploration Agency. [6] After the Jet Propulsion Lab (JPL) tested this antenna and found it better than their conventional 64-meter antennas, [ 7 ] they too switched to this method of construction for ...
In radio-frequency engineering and communications engineering, a waveguide is a hollow metal pipe used to carry radio waves. [1] This type of waveguide is used as a transmission line mostly at microwave frequencies, for such purposes as connecting microwave transmitters and receivers to their antennas, in equipment such as microwave ovens, radar sets, satellite communications, and microwave ...
The most common types of indoor antennas are the dipole [2] ("rabbit ears"), which work best for VHF channels, and loop antennas, which work best for UHF. [3] Outdoor antennas on the other hand are designed to be mounted on a mast on top of the owner's house, [4] or in a loft or attic where the dry conditions and increased elevation are ...
Those RTs with power settings can vary transmission range from approximately 200 meters (660 feet) to 10 kilometers (km) (6.2 miles). Adding a power amplifier increases the line of sight (LOS) range to approximately 40 km (25 miles). (These ranges are for planning purposes only; terrain, weather, and antenna height can affect transmission range.)
Instead of one antenna with omnidirectional coverage, the station may use as few as 3 (rural areas with few customers) or as many as 32 separate antennas, each covering a portion of the circular coverage. This allows the base station to use a directional antenna that is pointing at the user, which improves the signal-to-noise ratio. If the user ...
One of the latest approaches in beam steering involves Near-Field Meta-Steering (NFMS), [6] which uses phase-gradient metasurfaces placed in close proximity to a feed antenna. This method achieves 3D beam steering by employing compact structures that allow wide-angle control over both elevation and azimuth, proving highly effective for systems ...