Search results
Results from the WOW.Com Content Network
Wall framing in house construction includes the vertical and horizontal members of exterior walls and interior partitions, both of bearing walls and non-bearing walls. . These stick members, referred to as studs, wall plates and lintels (sometimes called headers), serve as a nailing base for all covering material and support the upper floor platforms, which provide the lateral strength along a
sill-beams (also called ground-sills or sole-pieces, at the bottom of a wall into which posts and studs are fitted using tenons), noggin-pieces (the horizontal timbers forming the tops and bottoms of the frames of infill panels), wall-plates (at the top of timber-framed walls that support the trusses and joists of the roof).
Laminated veneer lumber detail. Laminated veneer lumber (LVL) is an engineered wood product that uses multiple layers of thin wood assembled with adhesives.It is typically used for headers, beams, rimboard, and edge-forming material.
The beams are continuously formed, so the length of the beam is limited only to the maximum length that can be handled and transported. Typical widths are 3 + 1 ⁄ 2, 5 + 1 ⁄ 4 or 7 inches (89, 133 or 178 mm); typical depths are 9 + 1 ⁄ 2, 11 + 7 ⁄ 8, 14, 16 and 18 inches (240, 300, 360, 410 and 460 mm). Typically the beams are made to a ...
Cordwood masonry wall detail. The method is sometimes called stackwall because the effect resembles a stack of cordwood. A section of a cordwood home. Cordwood construction (also called cordwood masonry or cordwood building, alternatively stackwall or stovewood) is a term used for a natural building method in which short logs are piled crosswise to build a wall, using mortar or cob to ...
(UK) Breastsummer is a beam in a wall which carries the load over a large opening derived from breast being in the front, mid-level and summer: "A horizontal, bearing beam in a building; spec. the main beam supporting the girders or joists of a floor...". [6] "a main piece of timber that supports a building, an architrave between two pillars" [7]
Hammer beam trusses can have a single hammerbeam or multiple hammerbeams. A false hammerbeam roof (truss) has two definitions: 1) There is no hammer post on the hammer beam [16] [17] as sometimes found in a type of arch brace truss [18] or; 2)The hammer beam joins into the hammer post instead of the hammer post landing on the hammer beam. [19]
It is a rigid type of support or connection. The application of the fixed support is beneficial when we can only use single support, and people most widely used this type as the only support for a cantilever. [7] They are common in beam-to-column connections of moment-resisting steel frames and beam, column and slab connections in concrete frames.