Search results
Results from the WOW.Com Content Network
I've been searching and what I've seen claims that there is a capacitor in the bulb that causes a slight flicker depending what else is on the circuit, but again, that is the bulb. If the bulb flickers, the bulb flickers. In this case, the bulbs only flicker when using the new switches that glow when turned off.
In visual perception, flicker is a human-visible change in luminance of an illuminated surface or light source which can be due to fluctuations of the light source itself, or due to external causes such as due to rapid fluctuations in the voltage of the power supply (power-line flicker) or incompatibility with an external dimmer.
The original twinkle bulbs were C7½ and some C9¼ incandescent light bulbs with a bimetallic strip. Once the bulb warms up, the strip pulls slightly away from the contact, opening and interrupting the parallel circuit through the bulb and turning it off. The bulb then cools, allowing the strip to bend back and make contact again.
For premium support please call: 800-290-4726 more ways to reach us
Fluorescent lamps with magnetic ballasts flicker at a normally unnoticeable frequency of 100 or 120 Hz (twice of the utility frequency; the lamp is lit on both the positive and negative half-wave of a cycle). This flickering can cause problems for some individuals with light sensitivity [1] and are
Fluorescent lamps with magnetic ballasts flicker at a normally unnoticeable frequency of 100 or 120 Hz and this flickering can cause problems for some individuals with light sensitivity; [69] they are listed as problematic for some individuals with autism, epilepsy, [70] lupus, [71] chronic fatigue syndrome, Lyme disease, [72] and vertigo.
“Encourage activities and exposure to natural light during the day to support healthy sleep-wake cycles.” It's also crucial to try to avoid overstimulation in the evenings by limiting loud ...
A diamond may begin to glow while being rubbed; this occasionally happens to diamonds while a facet is being ground or the diamond is being sawn during the cutting process. Diamonds may fluoresce blue or red. Some other minerals, such as quartz, are triboluminescent, emitting light when rubbed together. [19]