Search results
Results from the WOW.Com Content Network
EMS-1 (The ITEC Electronic Modular Switch is an electronic direct control switching system. The modules are combined to form a complete switch or any of the modules can be added to your present Step-by-Step Systems.) EMS-2 (The EMS-2 RURAL SWITCH is a stored program control analog switch designed to be cost-effective in small exchanges.
A given headend may have between 1–12 CMTSs to service the cable modem population served by that headend or HFC hub. One way to think of a CMTS is to imagine a router with Ethernet interfaces (connections) on one side and coaxial cable RF interfaces on the other side. The Ethernet side is known as the Network Side Interface or NSI.
The DMS-100 is a member of the Digital Multiplex System (DMS) product line of telephone exchange switches manufactured by Northern Telecom. Designed during the 1970s and released in 1979, it can control 100,000 telephone lines. [1] The purpose of the DMS-100 Switch is to provide local service and connections to the PSTN public
A terminating resistor for a television coaxial cable is often in the form of a cap, threaded to screw onto an F connector. Antenna cables are sometimes used for internet connections; however, RG-6 should not be used for 10BASE2 (which should use RG-58) as the impedance mismatch can cause phasing problems with the baseband signal.
A telephone switch is the switching equipment of an exchange. A wire center is the area served by a particular switch or central office. A concentrator is a device that concentrates traffic, be it remote or co-located with the switch. An off-hook condition represents a circuit that is in use, e.g., when a telephone call is in progress.
Coaxial cable, or coax (pronounced / ˈ k oʊ. æ k s /), is a type of electrical cable consisting of an inner conductor surrounded by a concentric conducting shield, with the two separated by a dielectric (insulating material); many coaxial cables also have a protective outer sheath or jacket.
The first Ethernet standard, known as 10BASE5 (ThickNet) in the family of IEEE 802.3, specified baseband operation over 50 ohm coaxial cable, which remained the principal medium into the 1980s, when 10BASE2 (ThinNet) coax replaced it in deployments in the 1980s; both being replaced in the 1990s when thinner, cheaper twisted pair cabling came to dominate the market.
The BNC connector (initialism of "Bayonet Neill–Concelman") is a miniature quick connect/disconnect radio frequency connector used for coaxial cable. It is designed to maintain the same characteristic impedance of the cable, with 50 ohm and 75 ohm types being made. It is usually applied for video and radio frequency connections up to about 2 ...