Search results
Results from the WOW.Com Content Network
A strong joint, the tongue and groove joint is widely used for re-entrant angles. The effect of wood shrinkage is concealed when the joint is beaded or otherwise moulded. [ 1 ] In expensive cabinet work, glued dovetail and multiple tongue and groove are used.
A through [1] dado involves cuts which run between both edges of the surface, leaving both ends open. A stopped or blind [2] dado ends before one (stopped) or both (blind) of the cuts meets the edge of the surface. [1] A half dado is formed with a narrow dado cut into one part, coupled with a rabbet of another piece. This joint tends to be used ...
A through groove (left) and a stopped groove. In joinery, a groove is a slot or trench cut into a member which runs parallel to the grain. A groove is thus differentiated from a dado, which runs across the grain. [1] Grooves are used for a range of purposes in cabinet making and other woodworking fields.
1. A short piece of a log, especially one used for fuel. 2. A split-out piece of a bolt of wood. blind Joinery with mating surfaces not protruding through the face or end grain of the pieces being joined. An example is a "blind" mortise and tenon joint. bolster. Also called a pillow or cross head. 1. A shoulder. 2.
A tapered or scarfed finger joint is the most common joint used to form long pieces of lumber from solid boards; the result is finger-jointed lumber.. The finger joint can also be valuable when creating baseboards, moulding or trim, and can be used in such things as floor boards, and door construction.
For example: when constructing a four-sided box made from 19 mm thick material that is to be of finished size 600 mm × 600 mm, two of the members will be docked at 600 mm and the other two will be docked at 600 mm − 19 mm − 19 mm = 562 mm. Reinforced butt joints may require additional steps which are detailed below.
Tusked joints were found in a well near Leipzig, [4] created by early Neolithic Linear Pottery culture, and used in construction of the wooden lining of the wells. [5] Mortise and tenon joints have also been found joining the wooden planks of the " Khufu ship ", [ 6 ] a 43.6 m (143 ft) long vessel sealed into a pit in the Giza pyramid complex ...
This canal can be round, oval or an arc in order to receive another component such as a boss, a tongue or a gasket. It can also be on the circumference of a dowel, a bolt, an axle or on the outside or inside of a tube or pipe etc. This canal may receive a circlip, an o-ring, or a gasket.