Search results
Results from the WOW.Com Content Network
4-port 10BASE-T Ethernet hub with selectable MDI-X/MDI port 8-port Ethernet hub with one 10BASE2 connector and eight 10BASE-T ports. An Ethernet hub, active hub, network hub, repeater hub, multiport repeater, or simply hub [a] is a network hardware device for connecting multiple Ethernet devices together and making them act as a single network segment.
A repeater/repeater hub uses a jabber timer that ends retransmission to the other ports when it expires. The timer runs for 25,000 to 50,000 bit times for 1 Mbit/s, [ 59 ] 40,000 to 75,000 bit times for 10 and 100 Mbit/s, [ 60 ] [ 61 ] and 80,000 to 150,000 bit times for 1 Gbit/s. [ 62 ]
Unlike repeater hubs, which broadcast the same data out of each port and let the devices pick out the data addressed to them, a network switch learns the Ethernet addresses of connected devices and then only forwards data to the port connected to the device to which it is addressed. [8]
A four-port "long cable" "external box" USB hub A four-port "compact design" USB hub: upstream and downstream ports shown. A USB hub is a device that expands a single Universal Serial Bus (USB) port into several so that there are more ports available to connect devices to a host system, similar to a power strip. All devices connected through a ...
A hub is able to support low bandwidth devices mixed with other speed device via a special PID value, PRE. This is required as a USB hub functions as a very simple repeater, broadcasting the host message to all connected devices regardless if the packet was for it or not.
Exchanging cheap repeater hubs for more advanced switching hubs provided a viable upgrade path. Mixing different speeds in a single network became possible with the arrival of Fast Ethernet. Depending on cable grades, subsequent upgrading to Gigabit Ethernet or faster could be accomplished by replacing the network switches.
Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!
A crossover cable may also be used to connect two hubs or two switches on their upstream ports. Because the only difference between the T568A and T568B pin and pair assignments are that pairs 2 and 3 are swapped, a crossover cable may be envisioned as a cable with one modular connector following T568A and the other T568B (see TIA/EIA-568 wiring ...