Search results
Results from the WOW.Com Content Network
In logical block addressing, only one number is used to address data, and each linear base address describes a single block. The LBA scheme replaces earlier schemes which exposed the physical details of the storage device to the software of the operating system. Chief among these was the cylinder-head-sector (CHS) scheme, where blocks were addressed by means
The physical address of computer memory banks may be mapped to different logical addresses for various purposes. In a system supporting virtual memory, there may actually not be any physical memory mapped to a logical address until an access is attempted. The access triggers special functions of the operating system which reprogram the MMU to ...
Cylinder-head-sector (CHS) is an early method for giving addresses to each physical block of data on a hard disk drive. It is a 3D-coordinate system made out of a vertical coordinate head, a horizontal (or radial) coordinate cylinder, and an angular coordinate sector. Head selects a circular surface: a platter in the disk (and one of its two ...
DRBD is a distributed replicated storage system for the Linux platform. It mirrors block devices between multiple hosts, functioning transparently to applications on the host systems. This replication can involve any type of block device, such as hard drives, partitions, RAID setups, or logical volumes. [3]
The layout of a disk with the GUID Partition Table. In this example, each logical block is 512 bytes in size and each entry has 128 bytes. The corresponding partition entries are assumed to be located in LBA 2–33. Negative LBA addresses indicate a position from the end of the volume, with −1 being the last addressable block.
The Hack computer’s ROM module is presented as a linear array of individually addressable, sequential, 16-bit memory registers. Addresses start at 0 (0x0000). Since the memory elements are sequential devices, a system clock signal is supplied by the simulation application and the computer emulator application.
The address size used in logical block addressing was increased to 48 bits with the introduction of ATA-6. The Ext4 file system physically limits the file block count to 48 bits. The minimal implementation of the x86-64 architecture provides 48-bit addressing encoded into 64 bits; future versions of the architecture can expand this without ...
The term fixed-block architecture was created by IBM in 1979 [3] to distinguish this format from its variable-length record format. Each track is divided into fixed-length blocks, consisting of an ID field and a data field. Application programs refer to blocks by relative block number, and cannot address them by cylinder, head and record.