Search results
Results from the WOW.Com Content Network
UFAD systems use an underfloor supply plenum located between the structural concrete slab and a raised floor system to supply conditioned air to supply outlets (usually floor diffusers), located at or near floor level within the occupied space. Air returns from the room at ceiling level or the maximum allowable height above the occupied zone.
Non-residential ventilation rates are based on floor area and number of occupants, or a calculated dilution of known contaminants. [6] Hospital design standards use air changes per hour. [7] Recommended air changes rates can be found in relevant standards.
The heat can be transferred to the surrounding air using radiators, hot water coils (hydro-air), or other heat exchangers. The radiators may be mounted on walls or installed within the floor to produce floor heat. The use of water as the heat transfer medium is known as hydronics. The heated water can also supply an auxiliary heat exchanger to ...
The hot smoke heated the floor stones and the heat then radiated into the living spaces. These early forms have evolved into modern systems using fluid filled pipes or electrical cables and mats. Below is a chronological overview of under floor heating from around the world.
Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!
In Korea, the ondol system, meaning "warm stone," used flues beneath the floor to channel smoke from a kitchen stove, heating flat stones that radiated heat into the room above. Over time, the ondol system adapted to use coal and later transitioned to water-based systems in the 20th century, remaining a common heating system in Korean buildings ...
A New Mexico teenager has been charged with killing four members of his family, state police said on Sunday. According to a press release from New Mexico State Police, the teen was identified as ...
These motors are sometimes called DC motors, sometimes EC motors and occasionally DC/EC motors. DC stands for direct current and EC stands for electronically commutated.. DC motors allow the speed of the fans within a fan coil unit to be controlled by means of a 0-10 Volt input control signal to the motor/s, the transformers and speed switches associated with AC fan coils are not required.