enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. Key (engineering) - Wikipedia

    en.wikipedia.org/wiki/Key_(engineering)

    Square keys are used for smaller shafts and rectangular faced keys are used for shaft diameters over 6.5 in (170 mm) or when the wall thickness of the mating hub is an issue. Set screws often accompany parallel keys to lock the mating parts into place. [3] The keyway is a longitudinal slot in both the shaft and mating part.

  3. List of ISO standards 2000–2999 - Wikipedia

    en.wikipedia.org/wiki/List_of_ISO_standards_2000...

    ISO 2862:1974 Cinematography — Single-track magnetic sound record on 35 mm motion-picture films — Position and dimensions [Withdrawn without replacement] ISO 2863:1973 Cinematography — Motion-picture camera cartridge, 8 mm Type S Model II — Run length of film — Dimensions and specifications [Withdrawn without replacement]

  4. List of ISO standards 1–1999 - Wikipedia

    en.wikipedia.org/wiki/List_of_ISO_standards_1–1999

    ISO 286 Geometrical product specifications (GPS) — ISO code system for tolerances on linear sizes ISO 286-1:2010 Part 1: Basis of tolerances, deviations and fits; ISO 286-2:2010 Part 2: Tables of standard tolerance classes and limit deviations for holes and shafts

  5. Shaft (mechanical engineering) - Wikipedia

    en.wikipedia.org/wiki/Shaft_(mechanical_engineering)

    The following stresses are induced in the shafts. Shear stresses due to the transmission of torque (due to torsional load). Bending stresses (tensile or compressive) due to the forces acting upon the machine elements like gears and pulleys as well as the self weight of the shaft. Stresses due to combined torsional and bending loads.

  6. Hex key - Wikipedia

    en.wikipedia.org/wiki/Hex_key

    A hex key (also, hex wrench, Allen key and Allen wrench or Inbus) is a simple driver for bolts or screws that have heads with internal hexagonal recesses ().. Hex keys are formed from a single piece of hard hexagonal steel rod, having blunt ends that fit snugly into similarly shaped screw sockets.

  7. Engineering drawing abbreviations and symbols - Wikipedia

    en.wikipedia.org/wiki/Engineering_drawing...

    Many corporations have such standards, which define some terms and symbols specific to them; on the national and international level, ASME standard Y14.38 [1] is one of the standards. Australia utilises the Technical Drawing standards AS1100.101 (General Principals), AS1100-201 (Mechanical Engineering Drawing) and AS1100-301 (Structural ...

  8. Keyway - Wikipedia

    en.wikipedia.org/wiki/Keyway

    Keyway may refer to: A part of a keyed joint used to connect a rotating machine element to a shaft; see key (engineering) A keyhole , a hole or aperture (as in a door or lock) for receiving a key; see lock and key

  9. IEC 60309 - Wikipedia

    en.wikipedia.org/wiki/IEC_60309

    On the female socket, the major key is 4 mm deep at the 6-o'clock position. The width of the major key defines the current rating: 32 A plugs have a narrower 5 mm wide groove, while 16 A plugs have a wider 8 mm groove, and therefore 32 A plugs can be used with 16 A sockets but 16 A plugs cannot be used with 32 A sockets.