enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. Key (engineering) - Wikipedia

    en.wikipedia.org/wiki/Key_(engineering)

    Square keys are used for smaller shafts and rectangular faced keys are used for shaft diameters over 6.5 in (170 mm) or when the wall thickness of the mating hub is an issue. Set screws often accompany parallel keys to lock the mating parts into place. [3] The keyway is a longitudinal slot in both the shaft and mating part.

  3. Hex key - Wikipedia

    en.wikipedia.org/wiki/Hex_key

    A hex key (also, hex wrench, Allen key and Allen wrench or Inbus) is a simple driver for bolts or screws that have heads with internal hexagonal recesses ().. Hex keys are formed from a single piece of hard hexagonal steel rod, having blunt ends that fit snugly into similarly shaped screw sockets.

  4. Broaching (metalworking) - Wikipedia

    en.wikipedia.org/wiki/Broaching_(metalworking)

    Also, there are limits on the size of internal cuts. Common internal holes can range from 0.125 to 6 in (3.2 to 152.4 mm) in diameter but it is possible to achieve a range of 0.05 to 13 in (1.3 to 330.2 mm). Surface broaches' range is usually 0.075 to 10 in (1.9 to 254.0 mm), although the feasible range is 0.02 to 20 in (0.51 to 508.00 mm).

  5. Engineering drawing abbreviations and symbols - Wikipedia

    en.wikipedia.org/wiki/Engineering_drawing...

    CAD: computer-aided design, computer-aided drafting; cadmium [plating]: CAGE: Commercial and Government Entity [code]: A CAGE code is a unique identifier to label an entity (that is, a specific government agency or corporation at a specific site) that is a CDA, ODA, or MFR of the part defined by the drawing.

  6. List of DIN standards - Wikipedia

    en.wikipedia.org/wiki/List_of_DIN_standards

    This is an incomplete list of DIN standards.. The "STATUS" column gives the latest known status of the standard.. If a standard has been withdrawn and no replacement specification is listed, either the specification was withdrawn without replacement or a replacement specification could not be identified.

  7. Are doctors overtreating early-stage breast cancer? Is active ...

    www.aol.com/doctors-overtreating-early-stage...

    But a new study suggests this standard protocol might not be necessary for a common form of early-stage breast cancer. Ductal carcinoma in situ, or DCIS, accounts for up to 25% of diagnosed breast ...

  8. ASTM A325 - Wikipedia

    en.wikipedia.org/wiki/ASTM_A325

    ASTM A325 is an ASTM International standard for heavy hex structural bolts, titled Standard Specification for Structural Bolts, Steel, Heat Treated, 120/105 ksi Minimum Tensile Strength. It defines mechanical properties for bolts that range from 1 ⁄ 2 to 1 + 1 ⁄ 2 inches (13 to 38 mm) in diameter.

  9. Shaft (mechanical engineering) - Wikipedia

    en.wikipedia.org/wiki/Shaft_(mechanical_engineering)

    The following stresses are induced in the shafts. Shear stresses due to the transmission of torque (due to torsional load). Bending stresses (tensile or compressive) due to the forces acting upon the machine elements like gears and pulleys as well as the self weight of the shaft. Stresses due to combined torsional and bending loads.