Search results
Results from the WOW.Com Content Network
A safety wire is used to ensure proper security for a fastener. The wire needed is long enough to reach from a fixed location to a hole in the removable fastener, such as a pin — a clevis fastener, sometimes a linchpin or hitch-pin through a clevis yoke for instance — and the wire pulled back upon itself, parallel to its other end, then twisted, a single end inserted through a fastener ...
Safety harnesses have restraints that prevent the wearer from falling from a height. By wearing the belt or harness the risk of injury from a fall is greatly reduced. The harness allows the user to attach themselves to an object that is stationary, ensuring they will not hit the ground in the event of a possible fall.
Cable-stayed bridges with more than three spans involve significantly more challenging designs than do 2-span or 3-span structures. In a 2-span or 3-span cable-stayed bridge, the loads from the main spans are normally anchored back near the end abutments by stays in the end spans. For more spans, this is not the case and the bridge structure is ...
A cable gland (more often known in the U.S. as a cord grip, cable strain relief, cable connector or cable fitting) is a device designed to attach and secure the end of an electrical cable to the equipment. [1]
A more cable-friendly alternative is attaching the lines to special strain relief plates using common cable ties. In case of industrial applications these strain relief plates are also cost-effective because the packing density (meaning the possible number of lines to be fixed on one plate) is much higher than with common cable clamps which are ...
A sailboat's mast is supported by shrouds (side-to-side) and stays (fore-and-aft) – nautical equivalents of guy wires.. A guy-wire, guy-line, guy-rope, down guy, or stay, also called simply a guy, is a tensioned cable designed to add stability to a freestanding structure.
A fish tape (also called a draw wire, draw tape, or an electrician ' s snake) is a tool used by electricians to route new wiring through walls and electrical conduit. [1]Made of a narrow band of spring steel, by careful manipulation, the tape can be guided through confined spaces such as wall cavities or conduits in many countries.
The movable (less fixed) connector is classified as a plug (denoted P), [37] designed to attach to a wire, cable or removable electrical assembly. [38] This convention is currently defined in ASME Y14.44-2008, which supersedes IEEE 200-1975 , which in turn derives from the long-withdrawn MIL-STD-16 (from the 1950s), highlighting the heritage of ...