enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Flitch beam - Wikipedia

   en.wikipedia.org/wiki/Flitch_beam

   A flitch beam (or flitched beam) is a compound beam used in the construction of houses, decks, and other primarily wood-frame structures. Typically, the flitch beam is made up of a vertical steel plate sandwiched between two wood beams, the three layers being held together with bolts .

3. Span (engineering) - Wikipedia

   en.wikipedia.org/wiki/Span_(engineering)

   In engineering, span is the distance between two adjacent structural supports (e.g., two piers) of a structural member (e.g., a beam). Span is measured in the horizontal direction either between the faces of the supports (clear span) or between the centers of the bearing surfaces (effective span): [1] A span can be closed by a solid beam or by ...

4. Parallel-strand lumber - Wikipedia

   en.wikipedia.org/wiki/Parallel-strand_lumber

   The beams are continuously formed, so the length of the beam is limited only to the maximum length that can be handled and transported. Typical widths are 3 + 1 ⁄ 2 , 5 + 1 ⁄ 4 or 7 inches (89, 133 or 178 mm); typical depths are 9 + 1 ⁄ 2 , 11 + 7 ⁄ 8 , 14, 16 and 18 inches (240, 300, 360, 410 and 460 mm).

5. Deflection (engineering) - Wikipedia

   en.wikipedia.org/wiki/Deflection_(engineering)

   The deflection at any point, , along the span of a center loaded simply supported beam can be calculated using: [1] = for The special case of elastic deflection at the midpoint C of a beam, loaded at its center, supported by two simple supports is then given by: [ 1 ] δ C = F L 3 48 E I {\displaystyle \delta _{C}={\frac {FL^{3}}{48EI}}} where

6. Sandwich theory - Wikipedia

   en.wikipedia.org/wiki/Sandwich_theory

   For simple geometries such as double span beams under uniformly distributed loads, the governing equations can be solved by using appropriate boundary conditions and using the superposition principle. Such results are listed in the standard DIN EN 14509:2006 [5] (Table E10.1). Energy methods may also be used to compute solutions directly.

7. Hammerbeam roof - Wikipedia

   en.wikipedia.org/wiki/Hammerbeam_roof

   A hammer-beam is a form of timber roof truss, allowing a hammerbeam roof to span greater than the length of any individual piece of timber.In place of a normal tie beam spanning the entire width of the roof, short beams – the hammer beams – are supported by curved braces from the wall, and hammer posts or arch-braces are built on top to support the rafters and typically a collar beam.

8. Timber roof truss - Wikipedia

   en.wikipedia.org/wiki/Timber_roof_truss

   Hammer beam trusses can have a single hammerbeam or multiple hammerbeams. A false hammerbeam roof (truss) has two definitions: 1) There is no hammer post on the hammer beam [16] [17] as sometimes found in a type of arch brace truss [18] or; 2)The hammer beam joins into the hammer post instead of the hammer post landing on the hammer beam. [19]

9. Timber framing - Wikipedia

   en.wikipedia.org/wiki/Timber_framing

   The jetty beams or joists conform t floor dimensions above, but are at right angles to the jetty-plates that conform to the shorter dimensions of "roof" of the floor below. Jetty beams are mortised at 45° into the sides of the dragon beams. They are the main constituents of the cantilever system, and determine how far the jetty projects.