Search results
Results from the WOW.Com Content Network
The RS-25 engine consists of pumps, valves, and other components working in concert to produce thrust. Fuel (liquid hydrogen) and oxidizer (liquid oxygen) from the Space Shuttle's external tank entered the orbiter at the umbilical disconnect valves and from there flowed through the orbiter's main propulsion system (MPS) feed lines; whereas in the Space Launch System (SLS), fuel and oxidizer ...
Engine Origin Designer Vehicle Status Use Propellant Power cycle Specific impulse (s) [a] Thrust (N) [a] Chamber pressure (bar) Mass (kg) Thrust: weight ratio [e] Oxidiser: fuel ratio
The RS-25 engines were throttled at T+7 minutes 30 seconds to limit vehicle acceleration to 3 g. At 6 seconds prior to main engine cutoff (MECO), which occurred at T+8 minutes 30 seconds, the RS-25 engines were throttled down to 67%.
The RS-25 Space Shuttle main engine is another example of a staged combustion engine, and the first to use liquid oxygen and liquid hydrogen. [3] Its counterpart in the Soviet shuttle was the RD-0120 , which had similar specific impulse , thrust, and chamber pressure, but with some differences that reduced complexity and cost at the expense of ...
The AJ10-190 engines could be reused for up to 100 missions. Diagram of an RS-25 (or Space Shuttle Main Engine), that used a twin shaft staged combustion cycle. There were three of these on the back of the orbiter. Comparing the diagram of the RS-25 to that of the Orbital Manoeuvring System (OMS), it is clear that the RS-25 engine is far more ...
Propelled by 4 RS-25 engines, the stage generates approximately 7.44 MN (1,670,000 lb f) of thrust, about 25% of the Space Launch System's thrust at liftoff, for approximately 500 seconds, propelling the stage alone for the last 375 seconds of flight. The stage lifts the rocket to an altitude of approximately 162 km (531,380 ft) before ...
The core stage of the rocket is 8.4 meters (28 ft) in diameter and mount a Main Propulsion System (MPS) incorporating four RS-25 engines. [23] [24] The core stage is structurally similar to the Space Shuttle external tank, [25] [26] and initial flights will use modified RS-25D engines left over from the Space Shuttle program. [27]
Early designs of the Ares V utilized 5 standard-production SSMEs and a pair of 5-segment boosters identical to those proposed for the Shuttle, while later plans redesigned the boosters around the RS-68 rocket engine used on the Delta IV EELV system. Initially, NASA switched over to a system using the 5-segment boosters and a cluster of 5 RS-68s ...