Search results
Results from the WOW.Com Content Network
The startup and growth of SKF depends not only on technical inventions but also on industrial and corporate management strategies and power. Axel Carlander was a co-founder of SKF as a co-owner and member of the board of Gamlestadens Fabriker AB, which corporate policy provided conditions for experimenting with the new bearing models and the startup of SKF, and also he was the first chairman ...
For some types of garment, a single measure may not be sufficient to select the right product. In these cases, one or two "secondary dimensions" can be added to the label. The following table shows the primary (in bold) and secondary dimensions listed in the standard, leaving out the redundant words girth, length and size for better overview.
A sleeve, split, or clenched bushing is only a "sleeve" of material with an inner diameter (ID), outer diameter (OD), and length. The difference between the three types is that a solid sleeved bushing is solid all the way around, a split bushing has a cut along its length, and a clenched bearing is similar to a split bushing but with a clench ...
With the U.S. government on the verge of a partial shutdown, a timeline of more than 20 closures since 1976.
Oklahoma State is 3-6 and 0-6 in the Big 12 a season after making it to the Big 12 championship game. After starting the season with three straight non-conference wins, the Cowboys are in a tailspin.
A dance popularized by President-elect Donald Trump appears to have taken the sporting world by storm, after multiple US athletes across the country brought it out to celebrate plays this weekend.
The rate of taper is 1:20 on diameter, in other words 0.600" on diameter per foot, .050" on diameter per inch. Tapers range from a Number 2 to a Number 20. The diameter of the big end in inches is always the taper size divided by 8, the small end is always the taper size divided by 10 and the length is the taper size divided by 2.
A general practice is to size the sleeve two NPS (pipe sizes) up from the diameter of the penetrant. For example, a 4" pipe, with 1" of thermal insulation makes a 6" penetrant (1" pipe covering on each side of the pipe), plus two pipe sizes = an 8" sleeve, creating a 1" annulus.