Search results
Results from the WOW.Com Content Network
Data lines and control connected in parallel to a 16-bit data bus, and only chip selects connected independently per channel. To two halves of a 32-bit wide data bus, and the control lines in parallel, including chip select. To two independent 16-bit wide data buses; Each die provides 4, 6, 8, 12, or 16 gigabits of memory, half to each channel ...
A module of any particular size can therefore be assembled either from 32 small chips (36 for ECC memory), or 16(18) or 8(9) bigger ones. DDR memory bus width per channel is 64 bits (72 for ECC memory). Total module bit width is a product of bits per chip and number of chips. It also equals number of ranks (rows) multiplied by DDR memory bus width.
DDR4 RAM modules feature pins that are spaced more closely at 0.85 mm compared to the 1.0 mm spacing in DDR3, allowing for a higher pin density within the same standard DIMM length of 133.35 mm (5¼ inches). The height of DDR4 modules is slightly increased to 31.25 mm (1.23 inches) from 30.35 mm (1.2 inches
With the introduction of the Intel 840 (Pentium III), Intel 850 (Pentium 4), Intel 860 (Pentium 4 Xeon) chipsets, Intel added support for dual-channel PC-800 RDRAM, doubling bandwidth to 3200 MB/s by increasing the bus width to 32 bits. This was followed in 2002 by the Intel 850E chipset, which introduced PC-1066 RDRAM, increasing total dual ...
DDR3 memory chips are being made commercially, [11] and computer systems using them were available from the second half of 2007, [12] with significant usage from 2008 onwards. [13] Initial clock rates were 400 and 533 MHz, which are described as DDR3-800 and DDR3-1066 (PC3-6400 and PC3-8500 modules), but 667 and 800 MHz, described as DDR3-1333 ...
Earlier DIMM generations featured only a single channel and one CA (Command/Address) bus controlling the whole memory module with its 64 (for non-ECC) or 72 (for ECC) data lines. Both subchannels on a DDR5 DIMM each have their own CA bus, controlling 32 bits for non-ECC memory and either 36 or 40 data lines for ECC memory, resulting in a total ...
The table below shows values for PC memory module types. These modules usually combine multiple chips on one circuit board. SIMM modules connect to the computer via an 8-bit- or 32-bit-wide interface. RIMM modules used by RDRAM are 16-bit- or 32-bit-wide. [49] DIMM modules connect to the computer via a 64-bit-wide interface.
The current VME64 includes a full 64-bit bus in 6U-sized cards and 32-bit in 3U cards. The VME64 protocol has a typical performance of 40 MB /s. [ 3 ] Other associated standards have added hot-swapping ( plug-and-play ) in VME64x , smaller 'IP' cards that plug into a single VMEbus card, and various interconnect standards for linking VME systems ...