enow.com Web Search

  1. Ad

    related to: hot water recirculation line diagram

Search results

  1. Results from the WOW.Com Content Network
  2. Hydrothermal circulation - Wikipedia

    en.wikipedia.org/wiki/Hydrothermal_circulation

    Hydrothermal circulation in the oceans is the passage of the water through mid-oceanic ridge systems.. The term includes both the circulation of the well-known, high-temperature vent waters near the ridge crests, and the much-lower-temperature, diffuse flow of water through sediments and buried basalts further from the ridge crests. [3]

  3. Circulator pump - Wikipedia

    en.wikipedia.org/wiki/Circulator_pump

    The traditional hot water recirculation system uses the existing cold water line as return line from the point of use located farthest from the hot water tank back to the hot water tank. The first of two system types has a pump mounted at the hot water heater while a "normally open" thermostatic control valve gets installed at the farthest ...

  4. Central heating - Wikipedia

    en.wikipedia.org/wiki/Central_heating

    Circulating hot water can be used for central heating. Sometimes these systems are called hydronic heating systems. [22] Common components of a central heating system using water-circulation include: A supply of fuel, electric power or district heating supply lines; A boiler (or a heat exchanger for district heating) which heats water in the system

  5. Heat trap - Wikipedia

    en.wikipedia.org/wiki/Heat_trap

    Microcirculation on the left: Heated water is rising into the pipe on top of the hot water tank, cooling off on the sides of the pipe and thence circulating back into the tank. Right: Circulation of hot water is inhibited by the loop in the pipe. Heat traps are valves or loops of pipe on the cold water inlet and hot water outlet of water heaters.

  6. File:Active Indirect Water Heater Diagram.svg - Wikipedia

    en.wikipedia.org/wiki/File:Active_Indirect_Water...

    English: Active indirect water heater. 1: Municipal water feed 2: Fluid from water storage tank to external (passive) heat source; passive heat source can be the ground (soil or groundwater), sun or air; eg via heat pump, or thermodynamic solar panel 3: Fluid from heat pump, or thermodynamic solar panel to water storage tank 4: Pump, actuator, controller and other parts 5: Water heater 6 ...

  7. Water-tube boiler - Wikipedia

    en.wikipedia.org/wiki/Water-tube_boiler

    Schematic diagram of a marine-type watertube boiler. A high pressure watertube boiler [1] (also spelled water-tube and water tube) is a type of boiler in which water circulates in tubes heated externally by fire. Fuel is burned inside the furnace, creating hot gas which boils water in the

  8. Boiling water reactor - Wikipedia

    en.wikipedia.org/wiki/Boiling_water_reactor

    Another example was the Isolation Condenser system, which relied on the principle of hot water/steam rising to bring hot coolant into large heat exchangers located above the reactor in very deep tanks of water, thus accomplishing residual heat removal. Yet another example was the omission of recirculation pumps within the core; these pumps were ...

  9. Heat recovery steam generator - Wikipedia

    en.wikipedia.org/wiki/Heat_recovery_steam_generator

    A heat recovery steam generator (HRSG) is an energy recovery heat exchanger that recovers heat from a hot gas stream, such as a combustion turbine or other waste gas stream. It produces steam that can be used in a process ( cogeneration ) or used to drive a steam turbine ( combined cycle ).

  1. Ad

    related to: hot water recirculation line diagram