enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. API Standard 682 - Wikipedia

   en.wikipedia.org/wiki/API_Standard_682

   API Standard 682, titled "Pumps - Shaft Sealing Systems for Centrifugal and Rotary Pumps," is the American Petroleum Institute standard for end-face mechanical seals. [1] The purpose of API 682 is to assist in the selection and operation of end face mechanical seals in centrifugal pumps. It is based on the combined knowledge and experience of ...

3. Centrifugal pump - Wikipedia

   en.wikipedia.org/wiki/Centrifugal_pump

   Centrifugal pumps with an internal suction stage such as water-jet pumps or side-channel pumps are also classified as self-priming pumps. [10] Self-Priming centrifugal pumps were invented in 1935. One of the first companies to market a self-priming centrifugal pump was American Marsh in 1938. [citation needed]

4. End-face mechanical seal - Wikipedia

   en.wikipedia.org/wiki/End-face_mechanical_seal

   The first commercially successful mechanical seal to be used on centrifugal pumps was probably made by the Cameron Division of the Ingersoll-Rand Company. The Cameron seal was installed in a number of centrifugal pipeline pumps in 1928. [6] Mechanical seals in the 1930s often used a face combination of hardened steel versus leaded bronze.

5. Impeller - Wikipedia

   en.wikipedia.org/wiki/Impeller

   Several different types of pump impellers Flexible impeller of cooling system pump of an outboard engine (1 euro cent coin for comparison, diameter 16.25 mm). An impeller is a rotating component of a centrifugal pump that accelerates fluid outward from the center of rotation, thus transferring energy from the motor that drives the pump to the fluid being pumped.

6. Liquid-ring pump - Wikipedia

   en.wikipedia.org/wiki/Liquid-ring_pump

   Single-stage vacuum pumps typically produce vacuum to 35 torr (mm Hg) or 47 millibars (4.7 kPa), and two-stage pumps can produce vacuum to 25 torr, assuming air is being pumped and the ring-liquid is water at 15 °C (59 °F) or less. Dry air and 15 °C sealant-water temperature is the standard performance basis, which most manufacturers use for ...

7. Hydraulic seal - Wikipedia

   en.wikipedia.org/wiki/Hydraulic_seal

   A static hydraulic seal is located in a groove and sees no movement - only sealing within its confined space, acting like a gasket. To achieve this the gasket should be under pressure. The pressure is applied by tightening of the bolts. Examples of static seals include O-rings, flange seals, and cover seals. Dynamic