enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. List of conversion factors - Wikipedia

    en.wikipedia.org/wiki/List_of_conversion_factors

    cubic centimetre of atmosphere; standard cubic centimetre: cc atm; scc ≡ 1 atm × 1 cm 3 = 0.101 325 J: cubic foot of atmosphere; standard cubic foot: cu ft atm; scf ≡ 1 atm × 1 ft 3 = 2.869 204 480 9344 × 10 3 J: cubic foot of natural gas: ≡ 1000 BTU IT = 1.055 055 852 62 × 10 6 J: cubic yard of atmosphere; standard cubic yard: cu yd ...

  3. Cubic foot - Wikipedia

    en.wikipedia.org/wiki/Cubic_foot

    The IEEE symbol for the cubic foot per second is ft 3 /s. [1] The following other abbreviations are also sometimes used: ft 3 /sec; cu ft/s; cfs or CFS; cusec; second-feet; The flow or discharge of rivers, i.e., the volume of water passing a location per unit of time, is commonly expressed in units of cubic feet per second or cubic metres per second.

  4. Therm - Wikipedia

    en.wikipedia.org/wiki/Therm

    There is some ambiguity, as "decatherm" uses the prefix "d" to mean 10, where in metric the prefix "d" means "deci" or one-tenth, and the prefix "da" means "deca", or 10, though decatherm may use a capital "D". The energy content of 1,000 cubic feet (28 m 3) natural gas measured at standard conditions is approximately equal to one dekatherm.

  5. Help:Convert units - Wikipedia

    en.wikipedia.org/wiki/Help:Convert_units

    {{convert|123|cuyd|m3+board feet}} → 123 cubic yards (94 m 3; 40,000 board feet) The following converts a pressure to four output units. The precision is 1 (1 decimal place), and units are abbreviated and linked.

  6. British thermal unit - Wikipedia

    en.wikipedia.org/wiki/British_thermal_unit

    The energy content (high or low heating value) of a volume of natural gas varies with the composition of the natural gas, which means there is no universal conversion factor for energy to volume. 1 cubic foot (28 litres) of average natural gas yields ≈ 1,030 Btu (between 1,010 Btu and 1,070 Btu, depending on quality, when burned)

  7. Cubic metre - Wikipedia

    en.wikipedia.org/wiki/Cubic_metre

    A cubic metre of pure water at the temperature of maximum density (3.98 °C) and standard atmospheric pressure (101.325 kPa) has a mass of 1000 kg, or one tonne.At 0 °C, the freezing point of water, a cubic metre of water has slightly less mass, 999.972 kilograms.

  8. Liquid-to-gas ratio - Wikipedia

    en.wikipedia.org/wiki/Liquid-to-gas_ratio

    Most wet scrubbers used for particulate control operate with liquid-to-gas ratios in the range of 4 to 20 gallons per 1,000 actual cubic foot (0.5 to 3 litres per actual cubic metre). Depending on scrubber design, a minimum volume of liquid is required to "wet" the scrubber internals and create sufficient collection targets.

  9. Standard cubic foot - Wikipedia

    en.wikipedia.org/wiki/Standard_cubic_foot

    A standard cubic foot (scf) is a unit representing the amount of gas (such as natural gas) contained in a volume of one cubic foot at reference temperature and pressure conditions. It is the unit commonly used when following the customary system , a collection of standards set by the National Institute of Standards and Technology .