Search results
Results from the WOW.Com Content Network
Academic enquiry into the product lifetimes of electrical and electronic equipment was undertaken in 2000 by Cooper and Mayers [21] who conducted household interviews and focus groups to establish the age at discard (actual product lifetime) and expected lifetimes for 17 products. Since this study, work has been undertaken by other academics ...
The first piece of information added in an FMEDA is the quantitative failure data (failure rates and the distribution of failure modes) for all components being analyzed. The second piece of information added to an FMEDA is the probability of the system or subsystem to detect internal failures via automatic on-line diagnostics.
Many organizations maintain internal databases of failure information on the devices or systems that they produce, which can be used to calculate failure rates for those devices or systems. For new devices or systems, the historical data for similar devices or systems can serve as a useful estimate. Government and commercial failure rate data
High-temperature operating life (HTOL) is a reliability test applied to integrated circuits (ICs) to determine their intrinsic reliability. This test stresses the IC at an elevated temperature, high voltage and dynamic operation for a predefined period of time. The IC is usually monitored under stress and tested at intermediate intervals.
The difference between service life and predicted life is most clear when considering mission time and reliability in comparison to MTBF and service life. For example, a missile system can have a mission time of less than one minute, service life of 20 years, active MTBF of 20 minutes, dormant MTBF of 50 years, and reliability of 99.9999%.
IEC TS 62102 Electrical safety – Classification of interfaces for equipment to be connected to information and communications technology networks IEC 62104 Characteristics of DAB receivers IEC 62105 Digital audio broadcast system – Specification of the receiver data interface (RDI)
Electrical machines are usually designed with an average temperature below the rated hot-spot temperature to allow for acceptable life. Insulation does not suddenly fail if the hot-spot temperature is reached, but useful operating life declines rapidly; a rule of thumb is a halving of life for every 10 °C temperature increase.
The design life of a component or product is the period of time during which the item is expected by its designers to work within its specified parameters; in other words, the life expectancy of the item. It is not always the actual length of time between placement into service of a single item and that item's onset of wearout.