enow.com Web Search

  1. Ads

    related to: pulsed dc light to non led sensor

Search results

  1. Results from the WOW.Com Content Network
  2. Pulsed DC - Wikipedia

    en.wikipedia.org/wiki/Pulsed_DC

    Pulsed DC (PDC) or pulsating direct current is a periodic current which changes in value but never changes direction. Some authors use the term pulsed DC to describe a signal consisting of one or more rectangular ("flat-topped"), rather than sinusoidal, pulses. [1] Pulsed DC is commonly produced from AC (alternating current) by a half-wave ...

  3. Optical power meter - Wikipedia

    en.wikipedia.org/wiki/Optical_power_meter

    A class of laboratory power meters has an extended sensitivity, of the order of -110 dBm. This is achieved by using a very small detector and lens combination, and also a mechanical light chopper at typically 270 Hz, so the meter actually measures AC light. This eliminates unavoidable dc electrical drift effects.

  4. Blocking oscillator - Wikipedia

    en.wikipedia.org/wiki/Blocking_oscillator

    The non-sinusoidal output is not suitable for use as a radio-frequency local oscillator, but it can serve as a timing generator, to power lights, LEDs, EL wire, or small neon indicators. If the output is used as an audio signal, the simple tones are also sufficient for applications such as alarms or a Morse code practice device.

  5. Opto-isolator - Wikipedia

    en.wikipedia.org/wiki/Opto-isolator

    Schematic diagram of an opto-isolator showing source of light (LED) on the left, dielectric barrier in the center, and sensor (phototransistor) on the right [note 1]. An opto-isolator (also called an optocoupler, photocoupler, or optical isolator) is an electronic component that transfers electrical signals between two isolated circuits by using light. [1]

  6. Output signal switching device - Wikipedia

    en.wikipedia.org/wiki/Output_Signal_Switching_Device

    The non-tripped state is typically 24 VDC, and the tripped state (when the safety barrier has been violated) 0 VDC. If a wire were to break between the light curtain and the safety relay, the safety relay would trip to the safe state. The OSSD outputs are self-checked. In the non-tripped state, the outputs periodically pulse low.

  7. AOL Mail

    mail.aol.com

    Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!

  1. Ads

    related to: pulsed dc light to non led sensor