Ad
related to: digikey connector boots
Search results
Results from the WOW.Com Content Network
TTI, Inc., entered the European market in 1992 with its first office in Munich, Germany. Since that time the company’s European reach has spread to over 40 countries. In 2008, TTI acquired the Mateleco Group, a large connector distributor in France, becoming the primary distributor in both passives and connectors in France. [3]
DigiKey continued to grow following the recession in 2008. [9] By 2017, DigiKey was located in a single, centralized location in Thief River Falls, Minnesota that measured 800,000 square feet (74,000 m 2). In 2017 the company began work on a one million square foot expansion to their Thief River Falls facility at an expected cost of $200 ...
D-subminiature connectors are often used in industrial products, the DA-15 version being commonly used on rotary and linear encoders. DB-19 connector for an external floppy drive on a Macintosh 512K. The early Macintosh and late Apple II computers used a non-standard 19-pin D-sub for connecting external floppy disk drives.
DB13W3 (13W3) is a style of D-subminiature connector used for analog video interfaces. The 13 refers to the total number of pins, the W refers to workstation and the 3 refers to the number of high-frequency pins. The connector was something of a pseudo-standard for high-end graphical workstations from the early 1990s to the early 2000s.
Where BNC is used, available as 3 connectors with Sync on Green, or 5 connector Red / Green / Blue / Horizontal Sync / Vertical sync. Mac-II/Quadra DA15F: 1152 × 870 @ 75 [8] Macintosh: Mac-DA15F and Sun-13W3 were similar in capability to VGA. Some Sun machines used 4 or 5 BNC connectors to transfer video signal. 1990: 13W3 DB13W3: 1152 × 900 ...
The interface dimensions for SMA connectors are listed in MIL-STD-348. [5] The SMA connector employs a 1 ⁄ 4 inch diameter, 36-thread-per-inch threaded barrel. The male is equipped with a hex nut measuring 5 ⁄ 16 inch (0.3125 inch / 7.9 mm) across opposite flats, thus taking the same wrench as a #6 SAE hex nut.
A bias tee is a three-port network used for setting the DC bias point of some electronic components without disturbing other components. The bias tee is a diplexer.The low-frequency port is used to set the bias; the high-frequency port passes the radio-frequency signals but blocks the biasing levels; the combined port connects to the device, which sees both the bias and RF.
Some common DC power connectors. A DC connector (or DC plug, for one common type) is an electrical connector that supplies direct current (DC) power. Compared to domestic AC power plugs and sockets, DC connectors have many more standard types that are not interchangeable. The dimensions and arrangement of DC connectors can be chosen to prevent ...
Ad
related to: digikey connector boots