enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Pin header - Wikipedia

   en.wikipedia.org/wiki/Pin_header

   1×6 pin header (one row) 1×6 female header (one row) A pin header (or simply, header) is a form of electrical connector.A male pin header consists of one or more rows of metal pins molded into a plastic base, often 2.54 mm (0.1 in) apart, though available in many spacings. [1]

3. Board-to-board connector - Wikipedia

   en.wikipedia.org/wiki/Board-to-board_connector

   Board-to-board (BTB) connectors are used to connect printed circuit boards (PCB), electronic components that contain a conductive pattern printed on the surface of the insulating base in an accurate and repeatable manner. Each terminal on a BTB connector is connected to a PCB. A BTB connector includes housing and a specific number of terminals.

4. JST connector - Wikipedia

   en.wikipedia.org/wiki/JST_connector

   Wire-to-Board IDC connector series, sorted by pitch Archived 2022-02-12 at the Wayback Machine This page was last edited on 11 December 2024, at 09:18 (UTC). Text is ...

5. Reference designator - Wikipedia

   en.wikipedia.org/wiki/Reference_designator

   Connectors on this cable would be designated: 1A1W35P1; 1A1W35P2; ASME Y14.44-2008 continues the convention of Plug P and Jack J when assigning references for electrical connectors in assemblies where a J (or jack) is the more fixed and P (or plug) is the less fixed of a connector pair, without regard to the gender of the connector contacts.

6. Zero insertion force - Wikipedia

   en.wikipedia.org/wiki/Zero_insertion_force

   ZIF wire-to-board connectors are used for attaching wires to printed circuit boards inside electronic equipment. An example would be the cable between the LCD screen and motherboard in laptops. The wires, often formed into a ribbon cable, are pre-stripped and the bare ends are placed inside the connector. The two sliding parts of the connector ...

7. SMA connector - Wikipedia

   en.wikipedia.org/wiki/SMA_connector

   The interface dimensions for SMA connectors are listed in MIL-STD-348. [5] The SMA connector employs a 1 ⁄ 4 inch diameter, 36-thread-per-inch threaded barrel. The male is equipped with a hex nut measuring 5 ⁄ 16 inch (0.3125 inch / 7.9 mm) across opposite flats, thus taking the same wrench as a #6 SAE hex nut.