enow.com Web Search

  1. Ads

    related to: 8 ohm woofer replacement for air conditioner pump

Search results

  1. Results from the WOW.Com Content Network
  2. Constant-voltage speaker system - Wikipedia

    en.wikipedia.org/wiki/Constant-voltage_speaker...

    The voltage is constant only in the sense that at full power, the voltage in the system does not depend on the number of speakers driven (as long the amplifier's maximum power is not exceeded). [2] Constant-voltage speaker systems are also commonly referred to as 25- , 70- , 70.7- , 100 or 210-volt speaker systems ; distributed speaker systems ...

  3. Thiele/Small parameters - Wikipedia

    en.wikipedia.org/wiki/Thiele/Small_parameters

    American EIA standard RS-299A specifies that (or DCR) should be at least 80% of the rated driver impedance, so an 8-ohm rated driver should have a DC resistance of at least 6.4 ohms, and a 4-ohm unit should measure 3.2 ohms minimum. This standard is voluntary, and many 8-ohm drivers have resistances of ≈5.5 ohms, and proportionally lower for ...

  4. Loudspeaker - Wikipedia

    en.wikipedia.org/wiki/Loudspeaker

    A subwoofer is a woofer driver used only for the lowest-pitched part of the audio spectrum: typically below 200 Hz for consumer systems, [26] below 100 Hz for professional live sound, [27] and below 80 Hz in THX-approved systems. [28]

  5. LEAK Sandwich - Wikipedia

    en.wikipedia.org/wiki/LEAK_Sandwich

    Since it was designed for use with valve (tube) amplifiers, the system was rated at 15 Ohms. The 'Sandwich 200' model had a 200 mm (8 in) version of Barlow's foam-and-foil sandwich driver, together with two 60 mm (2.4 in) purple Mylar coned elements, one employed as a midrange, and the other as a tweeter.

  6. Speaker wire - Wikipedia

    en.wikipedia.org/wiki/Speaker_wire

    [citation needed] High-power in-car audio systems using 2-ohm speaker circuits require thicker wire than 4 to 8-ohm home audio applications. Most consumer applications use two conductor wire. A common rule of thumb is that the resistance of the speaker wire should not exceed 5 percent of the rated impedance of the system.

  7. Damping factor - Wikipedia

    en.wikipedia.org/wiki/Damping_factor

    However, some speakers require an amplifier with a low damping factor to reproduce rich, full-bodied sound. The E-202 has a Speaker Damping Control which permits choice of three damping factors and induces maximum potential performance from any speaker. Damping factor with an 8 Ω load becomes more than 50 when this control is set to NORMAL ...

  1. Ads

    related to: 8 ohm woofer replacement for air conditioner pump