Search results
Results from the WOW.Com Content Network
[7] [8] Many .17 Remington shooters have reported optimum accuracy when the bore is cleaned after every 10 - 20 shots, [7] [8] [9] though more modern metallurgy used in both barrels and bullets has largely mitigated the fouling issue. The .17 Remington is also one of the few cartridges in which powder charge weight is often greater than bullet ...
The most common rimfire cartridges are chambered for .17 caliber and .22 caliber. The bullet diameter for .17 caliber firearms generally measure .172 inch (4.37 mm), while the bullet diameter for .22 caliber firearms generally measure .222 inch (5.64 mm).
In 12.17×42mmRF and 12.18×44mmRF (two cartridges that were interchangeable), and towards the end of its service life also 8×58mmR Danish Krag centerfire, the rolling-block served as the standard service rifle of the Swedish Army from 1867 to the mid-1890s, when it was replaced by the Swedish Mauser.
The .17 Remington Fireball / 4.4x36mm was created in 2007 by Remington Arms Company as a response to the popular wildcat round, the .17 Mach IV. Factory loads drive a 20 grain (1.3 g) bullet around 4,000 ft/s (1,219 m/s).
Bought out by Remington in 1915 (becoming Remington-UMC Swanton but retaining the old headstamp) when it received a wartime contract to produce rifle ammunition for the French government. The French-style headstamp has the yearly quarter before the 4-digit year (e.g., 4-1917 would mean 4th Quarter (October, November and December), 1917).
The .17 Mach IV / 4.4x35mm is a wildcat centerfire rifle cartridge, based on the .221 Remington Fireball case, necked down to fire a 0.172 inches (4.4 mm) bullet. The cartridge was introduced in 1962 by Vern O’Brien. [1] The cartridge offered an easy case conversion and good ballistics, but could not compete against the .17 Remington. [3]
The .17-223 / 4.4x45mm is a centerfire wildcat rifle cartridge. It is based on the .223 Remington , but the neck is re-sized to accept a .17 caliber bullet. See also
The first variant has a push button selector on the hammer for choosing rimfire vs. centerfire, the second variant has a left-center-right toggle switch for selecting center fire-safe-rimfire firing pins, and the third variant has a horizontal bolt selection for choosing center fire-safe-rimfire firing pin positions.