Search results
Results from the WOW.Com Content Network
The drugs are classified in BCS on the basis of solubility and permeability. Solubility class boundaries are based on the highest dose strength of an immediate release product. A drug is considered highly soluble when the highest dose strength is soluble in 250 ml or less of aqueous media over the pH range of 1 to 6.8.
The drug apparent permeability (P app) is calculated by normalizing the drug flux (j) over the initial concentration of the API in the donor compartment (c 0) as: Equation 2: = / Dimensionally, the P app represents a velocity, and it is normally expressed in cm/sec. The highest is the permeability, the highest is expected to be the ...
Permeation can occur through most materials including metals, ceramics and polymers. However, the permeability of metals is much lower than that of ceramics and polymers due to their crystal structure and porosity. Permeation is something that must be considered carefully in many polymer applications, due to their high permeability.
The solubility of a specific solute in a specific solvent is generally expressed as the concentration of a saturated solution of the two. [1] Any of the several ways of expressing concentration of solutions can be used, such as the mass, volume, or amount in moles of the solute for a specific mass, volume, or mole amount of the solvent or of the solution.
The distribution of a drug between tissues is dependent on vascular permeability, regional blood flow, cardiac output and perfusion rate of the tissue and the ability of the drug to bind tissue and plasma proteins and its lipid solubility. pH partition plays a major role as well. The drug is easily distributed in highly perfused organs such as ...
Here, the green substance has a greater solubility in the lower layer than in the upper layer. The partition coefficient, abbreviated P, is defined as a particular ratio of the concentrations of a solute between the two solvents (a biphase of liquid phases), specifically for un-ionized solutes, and the logarithm of the ratio is thus log P.
The membrane is considered to have holes which the gas can dissolve (solubility) and the molecules can move from one cavity to the other (diffusion). [4] It was discovered by Robeson in the early 1990s that polymers with a high selectivity have a low permeability and opposite is true; materials with a low selectivity have a high permeability.
Electrical potential surface of paracetamol showing polar areas in red and blue. The polar surface area (PSA) or topological polar surface area (TPSA) of a molecule is defined as the surface sum over all polar atoms or molecules, primarily oxygen and nitrogen, also including their attached hydrogen atoms.