Search results
Results from the WOW.Com Content Network
The first tables of trigonometric functions known to be made were by Hipparchus (c.190 – c.120 BCE) and Menelaus (c.70–140 CE), but both have been lost. Along with the surviving table of Ptolemy (c. 90 – c.168 CE), they were all tables of chords and not of half-chords, that is, the sine function. [1]
In mathematics, tables of trigonometric functions are useful in a number of areas. Before the existence of pocket calculators, trigonometric tables were essential for navigation, science and engineering. The calculation of mathematical tables was an important area of study, which led to the development of the first mechanical computing devices.
In mathematics, the values of the trigonometric functions can be expressed approximately, as in (/), or exactly, as in (/) = /.While trigonometric tables contain many approximate values, the exact values for certain angles can be expressed by a combination of arithmetic operations and square roots.
This identity and analogous relationships between the other trigonometric functions are summarized in the following table. Top: Trigonometric function sin θ for selected angles θ, π − θ, π + θ, and 2 π − θ in the four quadrants. Bottom: Graph of sine versus angle. Angles from the top panel are identified.
Trigonometric functions were among the earliest uses for mathematical tables. [48] Such tables were incorporated into mathematics textbooks and students were taught to look up values and how to interpolate between the values listed to get higher accuracy. [49] Slide rules had special scales for trigonometric functions. [50]
On the other hand, if a function's domain is continuous, a table can give the values of the function at specific values of the domain. If an intermediate value is needed, interpolation can be used to estimate the value of the function. For example, a portion of a table for the sine function might be given as follows, with values rounded to 6 ...
Many commonly used functions are analytic functions, which can be expressed as power series, for example as a Taylor series. The initial values can be calculated to any degree of accuracy; if done correctly the engine will give exact results for first N steps. After that, the engine will only give an approximation of the function.
The following table gives an overview of Green's functions of frequently appearing differential operators, where = + +, = +, is the Heaviside step function, () is a Bessel function, () is a modified Bessel function of the first kind, and () is a modified Bessel function of the second kind. [2]