Ads
related to: tongue and groove cladding interior design
Search results
Results from the WOW.Com Content Network
Tongue and groove joints allow two flat pieces to be joined strongly together to make a single flat surface. Before plywood became common, tongue and groove boards were also used for sheathing buildings and to construct concrete formwork. A strong joint, the tongue and groove joint is widely used for re-entrant angles
39 in (990 mm) wainscoting using 3 in (76 mm) tongue and groove pine boards. Panelling (or paneling in the United States) is a millwork wall covering constructed from rigid or semi-rigid components. [1] These are traditionally interlocking wood, but could be plastic or other materials.
Matchboard by definition is "a board with a groove cut along one edge and a tongue along the other so as to fit snugly with the edges of similarly cut boards." [1]Bramble Cottage on Lundy Island, weathered cedar matchboarding in an exposed location
Clapboard is always referred to as weatherboard in New Zealand, where that type of cladding dominated in buildings constructed before 1960. After the big earthquakes of 1855 and 1931, wooden buildings were perceived as being less vulnerable to damage, and weatherboard walls with a corrugated iron roof was found to be a cost-effective building ...
A flat panel has its visible face flush with the front of the groove in the frame. This gives the panel an inset appearance. This style of panel is commonly made from man-made materials such as MDF or plywood but may also be made from solid wood or tongue and groove planks. Panels made from MDF will be painted to hide their appearance, but ...
The interior has offices opening off a central hall and has timber walls, ceiling and floor. A large sales counter sits in the front room, which has three quarter height partition walls clad in tongue and groove boards with some weatherboard cladding. Few interior fittings are present, these include two fixed safes and some shelves and drawers. [1]
Groove joint: Like the dado joint, except that the slot is cut with the grain. Sometimes referred to interchangeably with the dado joint. Tongue and groove: Each piece has a groove cut all along one edge, and a thin, deep ridge (the tongue) on the opposite edge. If the tongue is unattached, it is considered a spline joint. Birdsmouth joint
Also: egg and tongue, egg and anchor, egg and star; Fillet: Small, flat band separating two surfaces, or between the flutes of a column. Fillet is also used on handrail applications when the handrail is "plowed" to accept square shaped balusters. The fillet is used on the bottom side of the handrail between each of the balusters.
Ads
related to: tongue and groove cladding interior design