Search results
Results from the WOW.Com Content Network
When the output disk is adjusted to a position equal to its own radius, the resulting drive ratio is 1:1. The drive ratio can be set to infinity (i.e. a stationary output disk) by moving the output disk to the center of the input disk. The output direction can also be reversed by moving the output disk past the center of the input disk.
One-way bearing combining sprags and bearing rollers in one race Sprags jam when driven and slide when in reverse. A sprag clutch is a one-way freewheel clutch.It resembles a roller bearing but, instead of cylindrical rollers, non-revolving asymmetric figure-eight shaped sprags, or other elements allowing single direction rotation, are used.
The compact Comet shared a naming convention associated with the ongoing Space Race of the early 1960s with the Mercury Meteor, which was introduced as the base-trim full-size Mercury sedan. The Comet was initially based on the compact Ford Falcon, then on the intermediate Ford Fairlane, and finally on the compact Ford Maverick. Early Comets ...
AOL latest headlines, entertainment, sports, articles for business, health and world news.
A dual-clutch transmission (DCT) (sometimes referred to as a twin-clutch transmission) is a type of multi-speed vehicle transmission system, that uses two separate clutches for odd and even gear sets. [1] The design is often similar to two separate manual transmissions with their respective clutches contained within one housing, and working as ...
Before the introduction of transmission synchronizers in 1927, [2] double clutching was a technique required to prevent damage to an automobile's gearing during shifts. Due to the difficulty and most often unnecessary redundancy involved in the technique, coupled with the advent of synchronized gearing systems, it has largely fallen into disuse in light vehicles.
The output disks are connected to a gear, coupling, or pulley via drive cup. The clutch slips until the input and output RPMs are matched. This happens relatively quickly typically (0.2 - 2 sec). When the current is removed from the clutch, the armature is free to turn with the shaft.
The Comet J11 was manufactured from 1954 to 1955. Engine: Villiers Mk 4F (98cc) (47mm x 57mm), Carburetor was a Villiers Type 6/0; Transmission: Two speed with clutch. Frame: Single down tube; Suspension: Front was lightweight telescopic fork, plastic gaiters. Rear was a plunger-type. Brakes: 4" front, 5" rear; Drive: Chain and sprocket