Search results
Results from the WOW.Com Content Network
A birds-mouth joint in a rafter, set upon a double top plate. Shown are the two cuts of the joint: the seat cut and the heel cut. In light frame construction, a birdsmouth joint or bird's beak cut is a woodworking joint that is generally used to connect a roof rafter to the top plate of a supporting wall. [1]
Among its basic uses are marking common, hip, valley and hip, or valley jack rafters, laying out stair stringers, determining and marking angles, and making square cuts on boards. Common lines made using a speed square include perpendicular cut marks and Angles definition of an angle for roofs, stairways, and decks. The tool uses a 0° reference.
The side cut of the hip/valley rafter = (Tangent)(12) = side cut in inches. The side cuts in the rafter table are all in a base 12. The arc tan can be determined from any given pitch. Most power tools and angle measuring devices use 90° as 0° in construction. The complementary angles of the arc tan are used with tools like the speed square.
Compass rafter: A rafter curved or bowed on the top (the top surface of a rafter is called its "back") or both the top and bottom surfaces. Curb rafter: The upper rafters in a curb (kerb, gambrel, Mansard roof) roof. Hip rafter (angle rafter): The rafter in the corners of a hip roof. The foot of a hip rafter lands on a dragon beam.
Vomitorium: A passage situated below or behind a tier of seats. Control booth: The section of the theatre designated for the operation of technical equipment, followspots, lighting and sound boards, and is sometimes the location of the stage manager's station. The control booth is located in the theatre in such a way that there is a good ...
With kids out of school and several long holiday weekends—Memorial Day, Fourth of July, and Labor Day—summer is a popular time for travel.In fact, nearly half of Americans typically plan for ...
Cutting speed may be defined as the rate at the workpiece surface, irrespective of the machining operation used. A cutting speed for mild steel of 100 ft/min is the same whether it is the speed of the cutter passing over the workpiece, such as in a turning operation, or the speed of the cutter moving past a workpiece, such as in a milling operation.
In solid mechanics and structural engineering, section modulus is a geometric property of a given cross-section used in the design of beams or flexural members.Other geometric properties used in design include: area for tension and shear, radius of gyration for compression, and second moment of area and polar second moment of area for stiffness.