Search results
Results from the WOW.Com Content Network
Where BNC is used, available as 3 connectors with Sync on Green, or 5 connector Red / Green / Blue / Horizontal Sync / Vertical sync. Mac-II/Quadra DA15F: 1152 × 870 @ 75 [8] Macintosh: Mac-DA15F and Sun-13W3 were similar in capability to VGA. Some Sun machines used 4 or 5 BNC connectors to transfer video signal. 1990: 13W3 DB13W3: 1152 × 900 ...
The BNC connector is used for analog composite video and digital video interconnects on commercial video devices. Consumer electronics devices with RCA connector jacks can be used with BNC-only commercial video equipment by inserting an adapter. BNC connectors were commonly used on 10base2 thin Ethernet network cables and network cards. BNC ...
A keystone module for a CAT5 network cable A 3-port keystone wall plate. A keystone module is a standardized snap-in package for mounting a variety of low-voltage electrical jacks or optical connectors into a keystone wall plate, face plate, surface-mount box, or a patch panel.
A double DIN 1.6/5.6 bulkhead jack connector, crimp type, for 75 Ω coaxial cable A Type N connector (male), right-angled solder-type for semi-rigid coaxial cable with a diameter of 0.141-inch. 4.1-9.5 connector, standardized as DIN 47231 (in 1974) and IEC 60169-11 (in 1977) 4.3-10 connector, formerly known as DIN 4.3/10, now standardized as ...
A patch cable, patch cord or patch lead is an electrical or fiber-optic cable used to connect ("patch in") one electronic or optical device to another for signal routing. Devices of different types (e.g., a switch connected to a computer, or a switch to a router ) are connected with patch cords.
10BASE2 (also known as cheapernet, [1] thin Ethernet, thinnet, and thinwire) is a variant of Ethernet that uses thin coaxial cable terminated with BNC connectors to build a local area network. During the mid to late 1980s, this was the dominant 10 Mbit/s Ethernet standard.
A crossover cable may also be used to connect two hubs or two switches on their upstream ports. Because the only difference between the T568A and T568B pin and pair assignments are that pairs 2 and 3 are swapped, a crossover cable may be envisioned as a cable with one modular connector following T568A and the other T568B (see TIA/EIA-568 wiring ...
The connector looks almost identical to a typical BNC connector, but is designed to not mate with BNC jacks. It features two bayonet lugs on the female connector; mating is fully achieved with a quarter turn of the coupling nut. The dimensions of the connector are specified in the MIL-STD-348B. MHV connectors can be recognized by the slightly ...