Search results
Results from the WOW.Com Content Network
A keystone module for a CAT5 network cable A 3-port keystone wall plate. A keystone module is a standardized snap-in package for mounting a variety of low-voltage electrical jacks or optical connectors into a keystone wall plate, face plate, surface-mount box, or a patch panel.
The BNC connector is used for analog composite video and digital video interconnects on commercial video devices. Consumer electronics devices with RCA connector jacks can be used with BNC-only commercial video equipment by inserting an adapter. BNC connectors were commonly used on 10base2 thin Ethernet network cables and network cards. BNC ...
BNC tee connector. A tee connector is an electrical connector that connects three cables together. It is usually in the shape of a capital T. It is usually used for coax cables and the three connector points can be either female or male gender, and could be different or the same standard, such as F type, BNC or N type.
A patch cable, patch cord or patch lead is an electrical or fiber-optic cable used to connect ("patch in") one electronic or optical device to another for signal routing. Devices of different types (e.g., a switch connected to a computer, or a switch to a router ) are connected with patch cords.
Triaxial cable, often referred to as triax for short, is a type of electrical cable similar to coaxial cable, but with the addition of an extra layer of insulation and a second conducting sheath. Triax provides greater bandwidth and rejection of interference than coax, but is more expensive.
LEMO office in North America LEMO 00 coaxial connectors on RG316 cable, below a BNC to LEMO adapter, a male-to-male adapter barrel and a 50 Ω terminator (topmost). While LEMO connectors were generally developed as proprietary designs, the legal status of many of the older designs is not clear.
A crossover cable may also be used to connect two hubs or two switches on their upstream ports. Because the only difference between the T568A and T568B pin and pair assignments are that pairs 2 and 3 are swapped, a crossover cable may be envisioned as a cable with one modular connector following T568A and the other T568B (see TIA/EIA-568 wiring ...
The connector looks almost identical to a typical BNC connector, but is designed to not mate with BNC jacks. It features two bayonet lugs on the female connector; mating is fully achieved with a quarter turn of the coupling nut. The dimensions of the connector are specified in the MIL-STD-348B. MHV connectors can be recognized by the slightly ...