Search results
Results from the WOW.Com Content Network
Thrust reversal, also called reverse thrust, is the temporary diversion of an aircraft engine's thrust for it to act against the forward travel of the aircraft, providing deceleration. Thrust reverser systems are featured on many jet aircraft to help slow down just after touch-down, reducing wear on the brakes and enabling shorter landing ...
Thrust levers in a Boeing 747 Classic. The center and rear levers are used during flight, while the forward levers control reverse thrust.. Thrust levers or throttle levers are found in the cockpit of aircraft, and are used by the pilot, copilot, flight engineer, or autopilot to control the thrust output of the aircraft's engines, by controlling the fuel flow to those engines. [1]
Target-type thrust reversal (also called bucket thrust reversal or clamshell thrust reversal [1]) is a deceleration method when an aircraft lands. Like other types of thrust reversals, it temporarily diverts the engine exhaust forward to provide deceleration. This type of thrust-reverser is suitable for engines of 3,000 lbf (13 kN) or greater ...
This creates reverse thrust for braking or going backwards without the need to change the direction of shaft revolution. While some aircraft have ground-adjustable propellers, these are not considered variable-pitch. These are typically found only on light aircraft and microlights.
Thrust lever or throttle, which controls engine speed or thrust for powered aircraft. The control yokes also vary greatly among aircraft. There are yokes where roll is controlled by rotating the yoke clockwise/counterclockwise (like steering a car) and pitch is controlled by moving the control column towards or away from the pilot, but in ...
Pre-production F-15B with 2D nozzles, early 1980s, a predecessor of STOL/MTD program. In 1975, Langley Research Center began to conduct sponsored programs studying two-dimensional thrust vectoring nozzles; [6]: 44 government and industry studies of non-axisymmetric two-dimensional (2-D) nozzles in the early 1970s had identified significant payoffs for thrust-vectoring 2-D nozzle concepts.
A Beechjet 400A (a small business jet) with its left-hand Pratt and Whitney JT15D engine running at idle; and the engine's Nordam target-type or bucket thrust reverser being deployed three times after maintenance. Video shot by YSSYguy on 27 April 20...
At take-off, the flight crew advances the power lever to a predetermined setting, or opts for an auto-throttle take-off if available. The FADECs now apply the calculated take-off thrust setting by sending an electronic signal to the engines; there is no direct linkage to open fuel flow. This procedure can be repeated for any other phase of flight.